From abc7ed2c58860fc1363129efbe9e8c60f81a802c Mon Sep 17 00:00:00 2001 From: Weijie Gao Date: Sat, 29 Dec 2018 17:22:32 +0800 Subject: ath79: add support for D-Link DIR-859 A1 Hardware spec of DIR-859 A1: SoC: QCA9563 DRAM: 64MB DDR2 Flash: 16MB SPI-NOR Switch: QCA8337N WiFi 5.8GHz: QCA9880 USB is supported on the PCB but not connected. Flash instructions: 1. Upgrade the factory.bin through the factory web interface or the u-boot failsafe interface. The firmware will boot up correctly for the first time. Do not power off the device after OpenWrt has booted. Otherwise the u-boot will enter failsafe mode as the checksum of the firmware has been changed. 2. Upgrade the sysupgrade.bin in OpenWrt. After upgrading completes the u-boot won't complain about the firmware checksum and it's OK to use now. 3. If you powered off the device before upgrading the sysupgrade.bin, just upgrade the factory.bin through the u-boot failsafe interface and then goto step 2. Signed-off-by: Weijie Gao [squash commits, use common seama recipes, sync factory image recipe with ramips version] Signed-off-by: Mathias Kresin --- target/linux/ath79/config-4.14 | 1 + 1 file changed, 1 insertion(+) (limited to 'target/linux/ath79/config-4.14') diff --git a/target/linux/ath79/config-4.14 b/target/linux/ath79/config-4.14 index 969136ddde..5a2c685d40 100644 --- a/target/linux/ath79/config-4.14 +++ b/target/linux/ath79/config-4.14 @@ -168,6 +168,7 @@ CONFIG_MTD_PHYSMAP=y CONFIG_MTD_SPI_NOR=y CONFIG_MTD_SPLIT_FIRMWARE=y CONFIG_MTD_SPLIT_LZMA_FW=y +CONFIG_MTD_SPLIT_SEAMA_FW=y CONFIG_MTD_SPLIT_TPLINK_FW=y CONFIG_MTD_SPLIT_UIMAGE_FW=y CONFIG_MTD_TPLINK_PARTS=y -- cgit v1.2.3