From 12719ce37a0782a2e7b816020cdfca1973d5bc01 Mon Sep 17 00:00:00 2001 From: Michal Cieslakiewicz Date: Wed, 16 Oct 2019 12:41:34 +0200 Subject: ath79: add support for Netgear WNR2000 v3 This patch adds ath79 support for Netgear WNR2000v3. Router was previously supported by ar71xx target only. Note: this is a 4_32 device with limited upgrade capabilities. Specification ============= * Description: Netgear WNR2000 v3 * Loader: U-boot * SOC: Atheros AR7241 (360 MHz) * RAM: 32 MiB * Flash: 4 MiB (SPI NOR) - U-boot binary: 256 KiB - U-boot environment: 64 KiB - Firmware: 3712 KiB - ART: 64 KiB * Ethernet: 4 x 10/100 LAN + 1 x 10/100 WAN * Wireless: 2.4 GHz b/g/n (Atheros AR9287) * USB: no * Buttons: - Reset - WiFi (rfkill) - WPS * LEDs: - Power (amber/green) - WAN (amber/green) - WLAN (blue) - 4 x LAN (amber/green) - WPS (green) * UART: 4-pin connector JP1, 3.3V (Vcc, TX, RX, GND), 115200 8N1 * Power supply: DC 12V 1A * MAC addresses: LAN on case label, WAN +1, WLAN +2 Installation ============ * TFTP recovery * TFTP via U-boot prompt * sysupgrade * Web interface Test build configuration ======================== CONFIG_TARGET_ath79=y CONFIG_TARGET_ath79_tiny=y CONFIG_TARGET_ath79_tiny_DEVICE_netgear_wnr2000-v3=y CONFIG_ALL_KMODS=y CONFIG_DEVEL=y CONFIG_CCACHE=y CONFIG_COLLECT_KERNEL_DEBUG=y CONFIG_IMAGEOPT=y CONFIG_KERNEL_DEBUG_INFO=y CONFIG_KERNEL_DEBUG_KERNEL=y Signed-off-by: Michal Cieslakiewicz --- target/linux/ath79/base-files/etc/board.d/01_leds | 11 +++++++++++ target/linux/ath79/base-files/etc/board.d/02_network | 1 + .../ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom | 1 + 3 files changed, 13 insertions(+) (limited to 'target/linux/ath79/base-files/etc') diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds index 4ea9586d3d..97598ce45c 100755 --- a/target/linux/ath79/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/base-files/etc/board.d/01_leds @@ -111,6 +111,17 @@ glinet,gl-ar300m-lite) glinet,gl-x750) ucidef_set_led_netdev "wan" "WAN" "$boardname:green:wan" "eth1" ;; +netgear,wnr2000-v3) + ucidef_set_led_netdev "wan-amber" "WAN (amber)" "netgear:amber:wan" "eth0" + ucidef_set_led_switch "lan1green" "LAN1 (green)" "netgear:green:lan1" "switch0" "0x02" "0x04" + ucidef_set_led_switch "lan2green" "LAN2 (green)" "netgear:green:lan2" "switch0" "0x04" "0x04" + ucidef_set_led_switch "lan3green" "LAN3 (green)" "netgear:green:lan3" "switch0" "0x08" "0x04" + ucidef_set_led_switch "lan4green" "LAN4 (green)" "netgear:green:lan4" "switch0" "0x10" "0x04" + ucidef_set_led_switch "lan1amber" "LAN1 (amber)" "netgear:amber:lan1" "switch0" "0x02" "0x02" + ucidef_set_led_switch "lan2amber" "LAN2 (amber)" "netgear:amber:lan2" "switch0" "0x04" "0x02" + ucidef_set_led_switch "lan3amber" "LAN3 (amber)" "netgear:amber:lan3" "switch0" "0x08" "0x02" + ucidef_set_led_switch "lan4amber" "LAN4 (amber)" "netgear:amber:lan4" "switch0" "0x10" "0x02" + ;; netgear,wnr612-v2|\ on,n150r) ucidef_set_led_netdev "wan" "WAN" "netgear:green:wan" "eth0" diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 8e746d3970..5b50a6270b 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -205,6 +205,7 @@ ath79_setup_interfaces() ucidef_add_switch_port_attr "switch0" 2 led 9 ucidef_add_switch_port_attr "switch0" 5 led 2 ;; + netgear,wnr2000-v3|\ netgear,wnr612-v2|\ on,n150r|\ tplink,tl-wr740n-v1|\ diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom index 1caba14bf0..96b4fb0f8a 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom @@ -79,6 +79,7 @@ case "$FIRMWARE" in winchannel,wb2000) caldata_extract "art" 0x5000 0x440 ;; + netgear,wnr2000-v3|\ netgear,wnr612-v2|\ on,n150r|\ pcs,cap324|\ -- cgit v1.2.3