From 796ad2f7ef6fefcf821a3b21cadfdb7ef3126e95 Mon Sep 17 00:00:00 2001 From: Perry Melange Date: Wed, 7 Aug 2019 19:25:13 +0200 Subject: ath79: add support for D-Link DIR-842 C3 Hardware spec of DIR-842 C3: SoC: QCA9563 DRAM: 128MB DDR2 Flash: 16MB SPI-NOR Switch: QCA8337N WiFi 5.8GHz: QCA9888 WiFi 2.4Ghz: QCA9563 USB: circuit onboard, but components are not soldered Flash instructions: 1. Upgrade the factory.bin through the factory web interface or the u-boot failsafe interface. The firmware will boot up correctly for the first time. Do not power off the device after OpenWrt has booted. Otherwise the u-boot will enter failsafe mode as the checksum of the firmware has been changed. 2. Upgrade the sysupgrade.bin in OpenWrt. After upgrading completes the u-boot won't complain about the firmware checksum and it's OK to use now. 3. If you powered off the device before upgrading the sysupgrade.bin, just upgrade the factory.bin through the u-boot failsafe interface and then goto step 2. Signed-off-by: Perry Melange --- target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom | 1 + target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata | 1 + 2 files changed, 2 insertions(+) (limited to 'target/linux/ath79/base-files/etc/hotplug.d/firmware') diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom index a7d482580b..62d53248bc 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom @@ -107,6 +107,7 @@ case "$FIRMWARE" in ;; dlink,dir-842-c1|\ dlink,dir-842-c2|\ + dlink,dir-842-c3|\ dlink,dir-859-a1|\ nec,wg1200cr|\ wd,mynet-n750) diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index f6e2b801cb..501053e9d7 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -191,6 +191,7 @@ case "$FIRMWARE" in case $board in dlink,dir-842-c1|\ dlink,dir-842-c2|\ + dlink,dir-842-c3|\ nec,wg1200cr) ath10kcal_extract "art" 20480 12064 ath10kcal_patch_mac_crc $(mtd_get_mac_ascii devdata wlan5mac) -- cgit v1.2.3