From abc7ed2c58860fc1363129efbe9e8c60f81a802c Mon Sep 17 00:00:00 2001 From: Weijie Gao Date: Sat, 29 Dec 2018 17:22:32 +0800 Subject: ath79: add support for D-Link DIR-859 A1 Hardware spec of DIR-859 A1: SoC: QCA9563 DRAM: 64MB DDR2 Flash: 16MB SPI-NOR Switch: QCA8337N WiFi 5.8GHz: QCA9880 USB is supported on the PCB but not connected. Flash instructions: 1. Upgrade the factory.bin through the factory web interface or the u-boot failsafe interface. The firmware will boot up correctly for the first time. Do not power off the device after OpenWrt has booted. Otherwise the u-boot will enter failsafe mode as the checksum of the firmware has been changed. 2. Upgrade the sysupgrade.bin in OpenWrt. After upgrading completes the u-boot won't complain about the firmware checksum and it's OK to use now. 3. If you powered off the device before upgrading the sysupgrade.bin, just upgrade the factory.bin through the u-boot failsafe interface and then goto step 2. Signed-off-by: Weijie Gao [squash commits, use common seama recipes, sync factory image recipe with ramips version] Signed-off-by: Mathias Kresin --- target/linux/ath79/base-files/etc/board.d/02_network | 5 +++++ 1 file changed, 5 insertions(+) (limited to 'target/linux/ath79/base-files/etc/board.d/02_network') diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 004ab59573..1251048e08 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -158,6 +158,7 @@ ath79_setup_interfaces() ucidef_add_switch "switch0" \ "0@eth1" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "5:wan" "6@eth0" ;; + dlink,dir-859-a1|\ tplink,tl-wr1043nd-v4) ucidef_add_switch "switch0" \ "0@eth0" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "5:wan" @@ -234,6 +235,10 @@ ath79_setup_macs() lan_mac=$(mtd_get_mac_text "mac" 4) wan_mac=$(mtd_get_mac_text "mac" 24) ;; + dlink,dir-859-a1) + lan_mac=$(mtd_get_mac_ascii devdata "lanmac") + wan_mac=$(mtd_get_mac_ascii devdata "wanmac") + ;; elecom,wrc-300ghbk2-i) wan_mac=$(macaddr_add "$(mtd_get_mac_binary ART 4098)" -2) ;; -- cgit v1.2.3