From 1c2f7b511514d43d8a826b26e09817b2750a2bf4 Mon Sep 17 00:00:00 2001 From: Django Armstrong Date: Sun, 20 Jan 2019 16:46:42 +0000 Subject: ath79: add support for Devolo WiFi Pro 1750e Hardware -------- CPU: Qualcomm Atheros QCA9558 RAM: 128M DDR2 FLASH: 16MiB ETH: 1x Atheros AR8035 (PoE in) 1x Atheros AR8033 WiFi2: QCA9558 3T3R (SiGE SE2565T 2.4 GHz power amp x3) WiFi5: QCA9880 3T3R (Skyworks 5003L1 5 GHz power amp x3) BTN: 1x Reset 1x WPS 1x USB eject LED: 1x LED blue 1x LED red BEEP: 1x GPIO attached piezo beeper UART: 3.3V GND TX RX (115200-N-8) (3.3V is pin closest to rear ports) Dupont 4 pin header Rear RJ45 serial port non-functional USB: 1x v2.0 Installation ------------ Make sure you set a password for the root user as prompted on first setup! 1. Upload OpenWRT sysupgrade image via SSH to the device. Use /tmp as the destination folder on the device. User is root, password previously set in the web interface. 2. Install OpenWRT with > sysupgrade -n -F /tmp/ Signed-off-by: Django Armstrong --- target/linux/ath79/base-files/etc/board.d/02_network | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) (limited to 'target/linux/ath79/base-files/etc/board.d/02_network') diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 1569b110bd..4197f331b7 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -62,7 +62,8 @@ ath79_setup_interfaces() ucidef_add_switch "switch0" \ "0@eth0" "1:lan:1" "3:lan:4" "4:lan:3" "5:lan:2" "2:wan" ;; - devolo,dvl1200e) + devolo,dvl1200e|\ + devolo,dvl1750e) ucidef_set_interface_lan "eth0 eth1" ;; dlink,dir-825-b1) -- cgit v1.2.3