From 030fc6ab6cc1f4982809b65edf9c874d9117cd1f Mon Sep 17 00:00:00 2001 From: Jackson Lim Date: Thu, 25 Jul 2019 22:44:11 +0800 Subject: ath79: add support for D-Link DIR-842 C1 Hardware spec of DIR-842 C1: SoC: QCA9563 DRAM: 128MB DDR2 Flash: 16MB SPI-NOR Switch: QCA8337N WiFi 5.8GHz: QCA9888 WiFi 2.4Ghz: QCA9563 USB: circuit onboard, but components are not soldered Flash instructions: 1. Upgrade the factory.bin through the factory web interface or the u-boot failsafe interface. The firmware will boot up correctly for the first time. Do not power off the device after OpenWrt has booted. Otherwise the u-boot will enter failsafe mode as the checksum of the firmware has been changed. 2. Upgrade the sysupgrade.bin in OpenWrt. After upgrading completes the u-boot won't complain about the firmware checksum and it's OK to use now. 3. If you powered off the device before upgrading the sysupgrade.bin, just upgrade the factory.bin through the u-boot failsafe interface and then goto step 2. Signed-off-by: Jackson Lim [fix whitespace issues] Signed-off-by: David Bauer --- target/linux/ath79/base-files/etc/board.d/02_network | 2 ++ 1 file changed, 2 insertions(+) (limited to 'target/linux/ath79/base-files/etc/board.d/02_network') diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 9e44981022..4338b2955d 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -115,6 +115,7 @@ ath79_setup_interfaces() ;; dlink,dir-825-c1|\ dlink,dir-835-a1|\ + dlink,dir-842-c1|\ dlink,dir-842-c2|\ dlink,dir-859-a1|\ engenius,epg5000|\ @@ -307,6 +308,7 @@ ath79_setup_macs() lan_mac=$(mtd_get_mac_text "mac" 4) wan_mac=$(mtd_get_mac_text "mac" 24) ;; + dlink,dir-842-c1|\ dlink,dir-842-c2|\ dlink,dir-859-a1|\ nec,wg1200cr|\ -- cgit v1.2.3