From dc4eae7a8cf676911b0048b1e73c6f9adeea2f06 Mon Sep 17 00:00:00 2001 From: Christian Mehlis Date: Sun, 26 Feb 2017 12:25:57 +0100 Subject: ar71xx: Compex WPJ563 support Specification: - SoC: Qualcomm Atheros QCA9563 (775 MHz, MIPS 74Kc) - RAM: 128 MiB - Storage: 16MB NOR flash - Wireless: Built into QCA9563 (Dragonfly), PHY modes b/g/n, 3x3 MIMO - Ethernet: 2x1G Tested and working: - ethernet / switch / lan / wan - 2.4GHz SoC wifi - PCIe - leds - buzzer Ramload: - tftpboot 0x84000000 lede-ar71xx-generic-wpj563-16M-initramfs-uImage.bin - bootm 0x84000000 Install: - tftpboot 0x80500000 lede-ar71xx-generic-wpj563-16M-squashfs-sysupgrade.bin - erase 0x9f030000 +$filesize - erase 0x9f680000 +1 - cp.b $fileaddr 0x9f030000 $filesize Erasing 0x9f680000 is required because uboot defines "bootcmd=bootm 0x9f680000 || bootm 0x9f030000", so it first tries to boot the higher address. I think the 16 mb flash are intended to be used as 8+8mb for a fallback image. In my hardware only the lower address has a bootable image. But to make sure future hardware will boot lede too, I erase one block, so uboot will skip this address. Signed-off-by: Christian Mehlis --- target/linux/ar71xx/mikrotik/config-default | 1 + 1 file changed, 1 insertion(+) (limited to 'target/linux/ar71xx/mikrotik') diff --git a/target/linux/ar71xx/mikrotik/config-default b/target/linux/ar71xx/mikrotik/config-default index 1cc485a7d1..ecaa6e53d0 100644 --- a/target/linux/ar71xx/mikrotik/config-default +++ b/target/linux/ar71xx/mikrotik/config-default @@ -191,6 +191,7 @@ CONFIG_ATH79_MACH_RBSXTLITE=y # CONFIG_ATH79_MACH_WPJ344 is not set # CONFIG_ATH79_MACH_WPJ531 is not set # CONFIG_ATH79_MACH_WPJ558 is not set +# CONFIG_ATH79_MACH_WPJ563 is not set # CONFIG_ATH79_MACH_WRT160NL is not set # CONFIG_ATH79_MACH_WRT400N is not set # CONFIG_ATH79_MACH_WRTNODE2Q is not set -- cgit v1.2.3