| Commit message (Expand) | Author | Age | Files | Lines |
* | brcm47xx: fix Linksys E1200 V2 image filename | Rafał Miłecki | 2015-08-29 | 1 | -1/+1 |
* | bcm53xx: support sysupgrade with Netgear R7000 original firmware | Rafał Miłecki | 2015-08-26 | 1 | -0/+1 |
* | bcm53xx: add OpenWrt specific stuff for Netgear R7000 | Rafał Miłecki | 2015-08-26 | 8 | -2/+64 |
* | bcm53xx: use pending Netgear R7000 patch | Rafał Miłecki | 2015-08-26 | 4 | -118/+256 |
* | bcm53xx: use backported patches for UART0 and profiling | Rafał Miłecki | 2015-08-26 | 5 | -25/+17 |
* | brcm63xx: fix WAP-5813n default network config | Jonas Gorski | 2015-08-26 | 1 | -1/+1 |
* | linux: fix off-by-one in handling in /proc/net/route | Jonas Gorski | 2015-08-26 | 1 | -0/+46 |
* | brcm63xx: enable dual rx/tx spi support for hsspi | Jonas Gorski | 2015-08-25 | 3 | -4/+74 |
* | kernel: bridge, multicast-to-unicast: assign src after pskb_may_pull() | Felix Fietkau | 2015-08-25 | 2 | -37/+56 |
* | Revert "kernel: disable multicast-to-unicast translation for ipv6 neighbor so... | Felix Fietkau | 2015-08-25 | 2 | -40/+34 |
* | kernel: remove already upstream applied patch | Jonas Gorski | 2015-08-23 | 1 | -73/+0 |
* | adm5120: make patches apply again | Jonas Gorski | 2015-08-23 | 2 | -17/+17 |
* | kernel: update 4.1 to 4.1.6 | Jonas Gorski | 2015-08-23 | 10 | -166/+41 |
* | mvebu: kirkwood: fix ehci-orion probe if generic-phy isn't enabled | Jonas Gorski | 2015-08-23 | 3 | -0/+105 |
* | brcm63xx: ensure dummy byte is set for mapped spi flash with fast read | Jonas Gorski | 2015-08-23 | 18 | -78/+120 |
* | sunxi: bump to 4.1 | Zoltan Herpai | 2015-08-21 | 1 | -1/+3 |
* | sunxi: add audio module for 4.1 | Zoltan Herpai | 2015-08-21 | 1 | -0/+17 |
* | sunxi: update ahci package list for a couple board profiles | Zoltan Herpai | 2015-08-21 | 8 | -9/+16 |
* | sunxi: reorganize kmod-ata-sunxi dependencies | Zoltan Herpai | 2015-08-21 | 1 | -4/+2 |
* | This had been set in r44508 as a workaround for switch problems. | Imre Kaloz | 2015-08-21 | 1 | -2/+1 |
* | Previously, all VLANs (port-based or 802.1q) were sharing a single database i... | Imre Kaloz | 2015-08-21 | 2 | -4/+19 |
* | mvebu: fix cobra chainmask | Imre Kaloz | 2015-08-21 | 1 | -2/+2 |
* | kernel: add missing symbols for 4.1 | Zoltan Herpai | 2015-08-20 | 1 | -0/+3 |
* | mvebu: add support for the Linksys boot counter | Imre Kaloz | 2015-08-19 | 2 | -14/+20 |
* | at91: fix usb rate backport patch tab mangle | John Crispin | 2015-08-17 | 1 | -14/+14 |
* | orion: remove IRQF_DISABLED | John Crispin | 2015-08-17 | 1 | -2/+2 |
* | generic: crypto: remove IRQF_DISABLED | John Crispin | 2015-08-17 | 3 | -3/+3 |
* | lantiq: Support newer versions of the PEF7071 ethernet PHYs | John Crispin | 2015-08-17 | 2 | -2/+2 |
* | oxnas: remove support for kernel 3.18 and 4.0 | John Crispin | 2015-08-17 | 28 | -1554/+0 |
* | ramips: move patches around | John Crispin | 2015-08-17 | 1 | -0/+0 |
* | ramips: base-files: optimize etc/diag.sh and etc/board.d/01_leds scripts | John Crispin | 2015-08-17 | 2 | -424/+235 |
* | ramips: use consistent naming scheme for LEDs | John Crispin | 2015-08-17 | 80 | -612/+694 |
* | ar71xx: add support for TP-Link TL-WDR6500 v2 | John Crispin | 2015-08-17 | 11 | -1/+258 |
* | ar71xx: add 64kb bootloader mtd parser for tplinkpart | John Crispin | 2015-08-17 | 1 | -6/+29 |
* | ramips: reorder the sysupgrade script | John Crispin | 2015-08-17 | 1 | -13/+13 |
* | ramips: reorder patches | John Crispin | 2015-08-17 | 11 | -5/+3 |
* | ipq806x: switch AP148 to using SMEM based MTD parser | John Crispin | 2015-08-17 | 13 | -63/+35 |
* | ipq806x: add QCOM SMEM based MTD parser | John Crispin | 2015-08-17 | 2 | -0/+554 |
* | ipq806x: add SMEM support | John Crispin | 2015-08-17 | 6 | -0/+1918 |
* | ipq806x: add hwspinlock support | John Crispin | 2015-08-17 | 19 | -28/+958 |
* | kernel: move linux, part-probe dt parsing in generic code | John Crispin | 2015-08-17 | 18 | -53/+229 |
* | ar71xx: Add support for Black Swift | John Crispin | 2015-08-17 | 10 | -0/+172 |
* | at91: Backport determine_rate prototype fix | John Crispin | 2015-08-17 | 1 | -0/+20 |
* | mcs814x: use firmware partition splitter on dLAN USB Extender | John Crispin | 2015-08-17 | 3 | -9/+5 |
* | mcs814x: fix interrupt handling | John Crispin | 2015-08-17 | 2 | -22/+27 |
* | mcs814x: fix debug UART | John Crispin | 2015-08-17 | 2 | -3/+48 |
* | ramips: Fix MT7621 pinmux bits for uart3, uart2, mdio | John Crispin | 2015-08-17 | 1 | -9/+26 |
* | ramips: Fix amount of MT7621 pins controlled by spi group | John Crispin | 2015-08-17 | 1 | -1/+1 |
* | ramips: Fix uart2/uart3 pinmux order on MT7621 | John Crispin | 2015-08-17 | 1 | -4/+4 |
* | brcm2708: override disabled device tree module status from config.txt | John Crispin | 2015-08-17 | 1 | -0/+6 |