openwrt/upstream - upstream openwrt

	Commit message (Collapse)	Author	Age	Files	Lines
*	ramips: remove redundant nvmem definitions	Adrian Schmutzler	2021-08-20	1	-10/+0
\| \| \| \| \| \| \| \|	Due to use of a script when migrating from mtd-mac-address, a few of the definitions are redundant in DTSI and DTS files. Remove those. Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
*	ramips: convert mtd-mac-address to nvmem implementation	Ansuel Smith	2021-07-19	1	-2/+14
\| \| \| \| \| \| \|	Define nvmem-cells and convert mtd-mac-address to nvmem implementation. The conversion is done with an automated script. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
*	treewide: convert mtd-mac-address-increment* to generic implementation	Ansuel Smith	2021-07-19	1	-2/+2
\| \| \| \| \| \| \| \| \| \| \| \| \|	Rework patch 681-NET-add-mtd-mac-address-support to implement only the function to read the mac-address from mtd. Generalize mtd-mac-address-increment function so it can be applied to any source of of_get_mac_address. Rename any mtd-mac-address-increment to mac-address-increment. Rename any mtd-mac-address-increment-byte to mac-address-increment-byte. This should make simplify the conversion of target to nvmem implementation. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
*	ramips: add support for D-Link DIR-2640 A1	James McGuire	2020-11-11	1	-0/+34
	This patch adds support for D-Link DIR-2640 A1. Specifications: * Board: AP-MTKH7-0002 * SoC: MediaTek MT7621AT * RAM: 256 MB (DDR3) * Flash: 128 MB (NAND) * WiFi: MediaTek MT7615N (x2) * Switch: 1 WAN, 4 LAN (Gigabit) * Ports: 1 USB 2.0, 1 USB 3.0 * Buttons: Reset, WPS * LEDs: Power (blue/orange), Internet (blue/orange), WiFi 2.4G (blue), WiFi 5G (blue), USB 3.0 (blue), USB 2.0 (blue) Notes: * WiFi 2.4G and WiFi 5G LEDs are wired directly to the wireless chips Installation: * D-Link Recovery GUI: power down the router, press and hold the reset button, then re-plug it. Keep the reset button pressed until the power LED starts flashing orange, manually assign a static IP address under the 192.168.0.xxx subnet (e.g. 192.168.0.2) and go to http://192.168.0.1 * Some modern browsers may have problems flashing via the Recovery GUI, if that occurs consider uploading the firmware through cURL: curl -v -i -F "firmware=@file.bin" 192.168.0.1 MAC addresses: lan factory 0xe000 :a7 (label) wan factory 0xe006 :aa 2.4 factory 0xe000 +1 :a8 5.0 factory 0xe000 +2 :a9 Seems like vendor didn't replace the dummy entries in the calibration data. Signed-off-by: James McGuire <jamesm51@gmail.com> [fix device definition title] Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>