openwrt/upstream - upstream openwrt

	Commit message (Collapse)	Author	Age	Files	Lines
*	ramips: remove bogus ralink,mtd-eeprom with offset 0x4	Adrian Schmutzler	2019-12-28	1	-1/+0
\| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \|	Several devices in mt76x8 subtarget use the following line to set up wmac in their DTS(I) files: ralink,mtd-eeprom = <&factory 0x4> This is strange for several reasons: - They should use mediatek,mtd-eeprom on this SOC - The caldata is supposed to start at 0x0 - The parent DTSI mt7628an.dtsi specifies mediatek,mtd-eeprom anyway, starting from 0x0 - The offset coincides with the default location of the MAC address in caldata Based on the comment in b28e94d4bfa1 ("ramips: MiWiFi Nano fixes"), it looks like the author for this device wanted to actually use mtd-mac-address instead of ralink,mtd-eeprom. A check on the same device revealed that actually the MAC address start at offset 4 there, so the correct caldata offset is 0x0. Based on these findings, and the fact that the expected location on this SOC is 0x0, we remove the "ralink,mtd-eeprom = <&factory 0x4>" statement from all devices in ramips (being only mt7628an anyway). Thanks to Sungbo Eo for finding and researching this. Reported-by: Sungbo Eo <mans0n@gorani.run> Fixes: b28e94d4bfa1 ("ramips: MiWiFi Nano fixes") Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de> (cherry picked from commit 09d38a3bc328d122b0d84fcf6bb53d2bce7373b6)
*	ramips: add support for TOTOLINK LR1200	Chuanhong Guo	2019-06-05	1	-0/+156
	Specifications: - SoC: MT7628DAN (MT7628AN with 64MB built-in RAM) - Flash: 8M SPI NOR - Ethernet: 5x 10/100Mbps - WiFi: 2.4G: MT7628 built-in 5G: MT7612E - 1x miniPCIe slot for LTE modem (only USB pins connected) - 1x SIM slot Flash instruction: U-boot has a builtin web recovery page: 1. Hold the reset button while powering it up 2. Connect to the ethernet and set an IP in 192.168.1.0/24 range 3. Open your browser and upload firmware through http://192.168.1.1 Note about the LTE modem: If your router comes with an EC25 module and it doesn't show up as a QMI device, you should do the following to switch it to QMI mode: 1. Install kmod-usb-serial-option and a terminal software (e.g. minicom or screen). All 4 serial ports of the modem should be available now. 2. Open /dev/ttyUSB3 with the terminal software and type this AT command: AT+QCFG="usbnet",0 3. Power-cycle the router. You should now get a QMI device recognized. Signed-off-by: Chuanhong Guo <gch981213@gmail.com>