aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/ramips/dts/D240.dts
Commit message (Collapse)AuthorAgeFilesLines
* ramips: Improve Sanlinking D240 configKristian Evensen2017-03-111-0/+11
| | | | | | | | | | | | | | | | | * The left most mini-PCIe slot (the one attached to SIM2) can be power-cycled by setting GPIO 0 to high/low. * The D240 only needs the MT76x2 module, so update makefile to reflect this. Note that until the default mt7620 target is updated, then kmod-mt76 (and thus kmod-mt7603) will be selected by default. v2->v3: * Indentation error. v1->v2: * Rename gpio and remove redundant comment (thanks Piotr Dymacz) Signed-off-by: Kristian Evensen <kristian.evensen@gmail.com>
* ramips: replace remaining instances of ralink, port-mapDaniel Golle2017-02-151-1/+1
| | | | | | | | | | | | Some boards were apparently forgotten when ralink,portmap was renamed to mediatek,portmap -- probably because they used the long obsolete ralink,port-map attribute. If this commit breaks ethernet wan/lan assignment, this is because the port-map attribute wasn't actually parsed, you'll have to replace "wllll" by "llllw" in the dts file belonging to that board (and send a patch doing that!) Signed-off-by: Daniel Golle <daniel@makrotopia.org>
* ramips: add support for Sanlinking D240Kristian Evensen2017-02-051-0/+157
The Sanlinking Technologies D240 (http://www.sanlinking.com/en/29-dual-4g-wifi-router.html) is basically the same device as the ZBT WE826, so adding support for it in LEDE is straight forward. The differences is that the D240 has two mini-PCIe slots (instead of one), blue LEDs and supports PoE. Specification: * CPU: MT7620A * 1x 10/100Mbps POE (802.3af/802.3at) Ethernet, 4x 10/100Mbps. * 16 MB Flash. * 128 MB RAM. * 1x USB 2.0 port. * 2x mini-PCIe slots. * 2x SIM slots. * 1x 2.4Ghz WIFI. * 1x button. Wifi, USB, switch and both mini-PCIe slots are working. I have not been able to test the SD card reader. The device comes pre-installed with an older version of OpenWRT, including Luci. In order to install LEDE, you need to follow the existing procedure for updating OpenWRT/LEDE using Luci. I.e., you need to access the UI and update the firmware using the sysupgrade-image. Remember to select that you do not want to keep existing settings. The default router address is 192.168.10.1 and username/password admin/root (at least on my devices). If you brick the device, the procedure for recovery is the same as for the WE826. Please see the wiki page for that device for instructions. Signed-off-by: Kristian Evensen <kristian.evensen@gmail.com>