aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/brcm47xx/patches-3.14
Commit message (Collapse)AuthorAgeFilesLines
* kernel: update 3.14 to 3.14.18Luka Perkov2014-09-104-26/+4
| | | | | | | | Targets were build tested and patches are refreshed. Signed-off-by: Luka Perkov <luka@openwrt.org> SVN-Revision: 42463
* kernel: 3.14: update bcm47xxpartHauke Mehrtens2014-08-181-2/+2
| | | | | | | | It it used by brcm47xx and bcm53xx targets, so put patches in generic. Signed-off-by: Rafał Miłecki <zajec5@gmail.com> SVN-Revision: 42212
* brcm47xx: fix brcm47xx.legacy buildHauke Mehrtens2014-08-141-2/+2
| | | | | | | | we should check for ssb here. Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 42164
* brcm47xx: fix reboot problem on BCM4705/BCM4785Hauke Mehrtens2014-08-084-13/+36
| | | | | | | | | | | | | | This adds some code based on code from the Broadcom GPL tar to fix the reboot problems on BCM4705/BCM4785. I tried rebooting my device for ~10 times and have never seen a problem. This reverts the changes in the previous commit and adds the real fix as suggested by Rafał. Setting bit 22 in Reg 22, sel 4 puts the BIU (Bus Interface Unit) into async mode. Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 42088
* brcm47xx: 3.14: backport MIPS patches for early HIGHMEM supportHauke Mehrtens2014-08-075-2/+357
| | | | | | Signed-off-by: Rafał Miłecki <zajec5@gmail.com> SVN-Revision: 42053
* brcm47xx: 3.14: update MIPS patches with versions sent upstreamHauke Mehrtens2014-07-319-112/+147
| | | | | | Signed-off-by: Rafał Miłecki <zajec5@gmail.com> SVN-Revision: 41911
* brcm47xx: fix switch detection with kernel 3.14Hauke Mehrtens2014-07-171-0/+22
| | | | | | Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41706
* brcm47xx: fix LEDs on WRT54GL 1.1Hauke Mehrtens2014-07-152-7/+33
| | | | | | | Ticket: #17062 Signed-off-by: Rafał Miłecki <zajec5@gmail.com> SVN-Revision: 41666
* brcm47xx: improve board detection for some devicesHauke Mehrtens2014-07-143-0/+210
| | | | | | Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41662
* brcm47xx: make reboot a more reliableHauke Mehrtens2014-07-071-0/+17
| | | | | | | | | | | | A reboot is issued by setting the watchdog timer to a low value, when the value is decreased from 1 to 0 by the hardware the system will reboot. Setting this value to 1 does not work every time, it is a little bit more reliable when setting it to 3. This timer runs with some MHz or KHz so nobody will notice the increased waiting. Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41548
* brcm47xx: add buttons support for Netgear WNR3500LHauke Mehrtens2014-07-071-0/+25
| | | | | | | | Ticket: #14406 Signed-off-by: Rafał Miłecki <zajec5@gmail.com> SVN-Revision: 41547
* brcm47xx: fix bcm4705 rebooting when initializing the switch.Hauke Mehrtens2014-07-061-0/+17
| | | | | | | | | | | When the Ethernet controller is powered down and someone wants to access the mdio bus like the witch driver (b53) the system crashed if PCI_D3hot was set before. This patch deactivates this power sawing mode when a switch driver is in use. Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41527
* brcm47xx: add LEDs for Netgear WNR3500LHauke Mehrtens2014-07-051-1/+27
| | | | | | | | | https://dev.openwrt.org/ticket/14406 Signed-off-by: Rafał Miłecki <zajec5@gmail.com> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41520
* brcm47xx: make it possible to unregister the adm switchHauke Mehrtens2014-07-051-27/+47
| | | | | | Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41517
* brcm47xx: fix LEDs on WRTSL54GSHauke Mehrtens2014-07-051-1/+17
| | | | | | | | | https://dev.openwrt.org/ticket/16991 Signed-off-by: Rafał Miłecki <zajec5@gmail.com> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41516
* brcm47xx: increase fallback mac addresses by oneHauke Mehrtens2014-07-051-2/+2
| | | | | | | | | | Now the mac address is increased by two for the first fallback mac address. It could be that the address increased should be used for the wan port. Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41515
* brcm47xx: do not use mac addresses with 00:90:4C prefix, prevent mac address ↵Hauke Mehrtens2014-07-051-0/+68
| | | | | | | | | | | | | | collisions. The address prefix 00:90:4C is used by Broadcom in their initial configuration. When a mac address with the prefix 00:90:4C is used all devices from the same series are sharing the same mac address. To prevent mac address collisions we replace them with a mac address based on the base address. Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41513
* brcm47xx: add LEDs for Asus RT-N15U and update RT-N66UHauke Mehrtens2014-07-031-1/+38
| | | | | | Signed-off-by: Rafał Miłecki <zajec5@gmail.com> SVN-Revision: 41501
* brcm47xx: backport BCM47XX Linksys WRT54G series patchesHauke Mehrtens2014-07-023-0/+147
| | | | | | | Signed-off-by: Rafał Miłecki <zajec5@gmail.com> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 41486
* brcm47xx: refresh patchesHauke Mehrtens2014-04-083-4/+4
| | | | | | Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 40425
* brcm47xx: Name LEDs colors for Linksys E1000 V2.1Hauke Mehrtens2014-03-301-0/+13
| | | | | | | | | Handle it by creating a new patch for simple database changes. Signed-off-by: Rafał Miłecki <zajec5@gmail.com> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 40345
* brcm47xx: update workarounds patch to V3Hauke Mehrtens2014-03-301-3/+9
| | | | | | | Signed-off-by: Rafał Miłecki <zajec5@gmail.com> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 40344
* brcm47xx: add initial support for kernel 3.14Hauke Mehrtens2014-03-1221-0/+1786
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 39905