aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/ar71xx/config-2.6.39
Commit message (Collapse)AuthorAgeFilesLines
* ar71xx: support for D-LINK DIR-615 rev. E4Gabor Juhos2012-01-311-0/+1
| | | | | | | | | | | | | | | | | | | | This patch adds support for D-LINK DIR-615 E4 board. It's mostly based on the existing support for DIR-600 A1, with some changes in the leds configuration. It's an updated version of the patch that reliably works on my hw for about a year (it was built from trunk on Jan 2011). When I decided to update the firmware and checked for the current support for that device, I also found previously posted patches by Alexey Loukianov that mentioned some stability issues. I'm not sure where could be the difference, the patches are very similar except the wmac led pin number - I was using 1, and those patches used 17. [juhosg: add 3.2 support] Signed-off-by: Vadim Girlin <vadimgirlin@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29973 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add support for TP-Link TL-MR11UGabor Juhos2012-01-311-0/+1
| | | | | | | | | | | | | | | | | | | Adds support for TL-MR11U, a portable router with very similar hardware to the TL-WR703N and TL-MR3020, but with an onboard 2000mAh battery. Tested, working: All interfaces (Ethernet, 802.11n, USB) WPS & Reset switches (Power appears to be a hardware slider) Ethernet, Wifi, 3G LEDs (Power & charging LEDs hardware controlled) Sysupgrade [juhosg: fix indentations to use TABs instead of spaces, fix 3.2 patch breakage] Signed-off-by: Simon Taylor <simon.taylor.uk@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29972 3c298f89-4303-0410-b956-a3cf2f4a3e73
* [ar71xx] add support for the Atheros AP113 reference boardFlorian Fainelli2012-01-281-0/+1
| | | | | | | | | This reference board is equipped with: - AR7242 SoC - AR9580 on-board Wi-Fi - AR8316 switch git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29935 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add support for Compex WPE72/WPE72NXGabor Juhos2012-01-261-0/+1
| | | | | | | | | | | This patch adds support for Compex WPE72 bare board and Compex WPE72NX Indoor Access Point. [juhosg: add support to 3.2 as well] Signed-off-by: Johnathan Boyce <jon.boyce@globalreach.eu.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29912 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add initial support for the TL-WR2543N/ND boardGabor Juhos2012-01-071-0/+2
| | | | | | The WLAN LEDs are not working yet. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29680 3c298f89-4303-0410-b956-a3cf2f4a3e73
* generic: improve MIPS kexec supportGabor Juhos2012-01-071-1/+1
| | | | | | | | | | | | | It is based on patches from the linux-longsoon-community git tree: http://dev.lemote.com/cgit/linux-loongson-community.git/ Now the kernel can use the command line parameter from kexec-tools. Runtime tested on ar71xx with 2.6.39.4 (the wathdog must be stopped before executing the new kernel). Compile tested with lantiq (3.1.4) and brcm47xx (3.0.12). git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29674 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add support for Redwave RW2458NGabor Juhos2012-01-061-0/+1
| | | | | | Signed-off-by: Cezary Jackiewicz <cezary.jackiewicz@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29669 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add inital support for the ALFA Network AP96 boardGabor Juhos2012-01-041-0/+1
| | | | | | | | The microSD slot and the Real Time Clock is not working yet. The miniPCIe interface is not tested due to the lack of a suitable card. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29662 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add support for TP-Link TL-MR3020Gabor Juhos2012-01-041-0/+1
| | | | | | | | | | | | | | | | | | | | | | | | This patch adds support for the TP-Link device TL-MR3020 which is very similiar to the TL-WR703N. The TL-MR3020 uses 5 LEDs, 1 push button and a switch with 3 positions. Only four LEDs can be controlled via GPIO. The power LED is connected to the power supply. The WPS push button has been mapped to KEY_WPS_BUTTON. The two GPIO signals of the sliding switch have been mapped to BTN_0 and BTN_1. I have also setup a wiki page with details here: http://wiki.openwrt.org/toh/tp-link/tl-mr3020 USB is working and has been tested with USB mass storage and USB UMTS stick. Wifi also seems to work. Ethernet is working too. Signed-off-by: Christian Cier-Zniewski <c.cier@gmx.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29651 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add support for the ALFA Network N2/N5 boardsGabor Juhos2012-01-011-0/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29635 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: enable SWCONFIG_LEDSGabor Juhos2011-12-311-0/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29630 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add support for the wzr-hp-g300nh2Felix Fietkau2011-12-181-0/+1
| | | | | | Signed-off-by: Mark Deneen <mdeneen@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29567 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add support for ALFA Network's Hornet-UB boardGabor Juhos2011-12-141-0/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29535 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add preliminary support for wzr-hp-g450hFelix Fietkau2011-12-051-0/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29441 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add mtd partition parser for the TP-Link boardsGabor Juhos2011-12-031-0/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29415 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: enable WHR-HP-G300N support in kernel configGabor Juhos2011-11-071-1/+1
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28801 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add initial support for the TL-WR741ND v4 boardGabor Juhos2011-11-011-0/+1
| | | | | | The ethernet port LEDs are not working yet. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28706 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add initial support for the OpenMesh OM2P boardGabor Juhos2011-10-271-0/+1
| | | | | | Based on a patch by Marek Lindner <marek@open-mesh.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28617 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: Buffalo WHR-HP-G300N kernel supportGabor Juhos2011-10-241-0/+1
| | | | | | | | | | | | | The initial support for the Buffalo WHR-HP-G300N box. The code was confirmed to boot and run, but not tested in depth. Known problem: iw phy phy0 info shows: Coverage class: 0 (up to 0m) Available Antennas: TX 0 RX 0 Signed-off-by: Yoichi Shinoda <shinoda@jaist.ac.jp> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28567 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add kernel support for the Allnet ALL0258N boardGabor Juhos2011-10-241-0/+1
| | | | | | | | | | This patchs adds support for the Allnet ALL0258N outdoor AP/bridge. The ALL0258N is based on the AR7240 SoC paired with an AR9285 radio, it got 8MB of NOR and 32MB SDRAM. Signed-off-by: Daniel Golle <dgolle@allnet.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28564 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: don't override CONFIG_FSNOTIFYGabor Juhos2011-10-241-1/+0
| | | | git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28563 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add support for the TP-Link TL-WR703N v1 boardGabor Juhos2011-09-211-0/+1
| | | | | | Based on a patch by dongyuqi <729650915@qq.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28277 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ar71xx: add 2.6.39 supportGabor Juhos2011-06-291-0/+203
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@27310 3c298f89-4303-0410-b956-a3cf2f4a3e73
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-10 05:26:36 +0000