| Commit message (Collapse) | Author | Age | Files | Lines |
... | |
|
|
|
|
|
|
|
|
| |
This is for security precautions. As persist_tun and persist_key are
already there, this should not cause compatibility issue.
Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com>
SVN-Revision: 45961
|
|
|
|
|
|
|
|
|
| |
As reported in ticket #19104, auth_retry takes a <type> argument with 3
choices: none, nointeract, interact.
Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com>
SVN-Revision: 45960
|
|
|
|
|
|
| |
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 45959
|
|
|
|
|
|
|
|
|
| |
In new firmware-4.bin (for ath10k) mac offset is 0x114 (276), not 0x118 (280).
This also closes #19751, bug introduced in #45624
Signed-off-by: Cezary Jackiewicz <cezary.jackiewicz@gmail.com>
SVN-Revision: 45958
|
|
|
|
|
|
| |
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 45957
|
|
|
|
|
|
|
|
| |
They are of 32-bit little endian integers.
Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com>
SVN-Revision: 45956
|
|
|
|
|
|
| |
Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com>
SVN-Revision: 45955
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
The mynet range extender hardware is suffering from ethernet
link loss when booting with a recent openwrt image. This only
happens on 100mbps links, with 1Gbps speed the link was fine.
The cause of the problem is that the AR8035 PHY (aka F1E)
requires turning on and off the special TX delay setting
depending on the speed of the link.
The 10mbps mode only needed the proper pll value, which was
extracted from the vendor code.
Reported-by: Pascal Paradis
Signed-off-by: Christian Lamparter <chunkeey@googlemail.com>
SVN-Revision: 45954
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
- fix iconv detection because it adds host paths
- disable python detection (host python-config is found)
iconv issue is reported by buildbot config.log + replicated locally
see config.log in logs.tar.gz
python issue observed locally on Arch Linux
Signed-off-by: Dirk Neukirchen <dirkneukirchen@web.de>
SVN-Revision: 45953
|
|
|
|
|
|
| |
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 45952
|
|
|
|
|
|
| |
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45950
|
|
|
|
|
|
| |
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45949
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Adds PPP unnumbered support via the parameter unnumbered which points to a logical OpenWRT interface.
The PPP proto shell handler will "borrow" an IP address from the unnumbered interface (if multiple
IP addresses are present the longest prefix different from 32 will be "borrowed") for which a host
interface dependency will be created. Due to the host interface dependency the PPP unnumbered interface
will only "borrow" an IP address from an interface which is up.
The borrowed IP address will be shared as local IP address by the PPP daemon and no other local IP
will be accepted from the peer in the IPCP negotiation.
A typical use case is the usage of a public IP subnet on the Lan interface which will be shared
by the PPP interface as local IP address.
Signed-off-by: Hans Dedecker <dedeckeh@gmail.com>
SVN-Revision: 45948
|
|
|
|
|
|
|
|
| |
CVE-2015-1792 CVE-2015-1791
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45947
|
|
|
|
|
|
| |
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45946
|
|
|
|
|
|
|
|
|
|
|
|
| |
When r42245 moved A4001N to DT based detection the image padding size
was accidentally increased from 4 to 8 MiB. This made images unflashable
on these devices.
Fixes #19836.
Signed-off-by: Jonas Gorski <jogo@openwrt.org>
SVN-Revision: 45945
|
|
|
|
|
|
| |
Signed-off-by: Imre Kaloz <kaloz@openwrt.org>
SVN-Revision: 45944
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45943
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45942
|
|
|
|
|
|
|
|
| |
Thanks to Mikael Abrahamsson for reporting.
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45941
|
|
|
|
|
|
|
|
|
| |
Commit 31214c38c8dd0f70366b523f9b0335145b9386bd removes IPv6 unneeded source-dest-routing workarounds;
as a result sourcerouting parameter is unused and can be removed.
Signed-off-by: Hans Dedecker <dedeckeh@gmail.com>
SVN-Revision: 45940
|
|
|
|
|
|
|
|
|
| |
Commit 31214c38c8dd0f70366b523f9b0335145b9386bd removes IPv6 unneeded source-dest-routing workarounds;
as a result sourcerouting parameter is unused and can be removed.
Signed-off-by: Hans Dedecker <dedeckeh@gmail.com>
SVN-Revision: 45939
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
On device reset the sizes for the vlan and port tables were wrongly
calculated based on the pointer size instead of the struct size. This
causes buffer overruns on 64 bit targets, resulting in panics.
Fix this by dereferencing the pointers.
Reported-by: Fedor Konstantinov <blmink@mink.su>
Signed-off-by: Jonas Gorski <jogo@openwrt.org>
SVN-Revision: 45938
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
At least on my b53 chip, the mask is 3 bits wide, and because
of this some STP states are not set properly and discarded when read.
Maybe for some other chips it makes sense to have just 2 bits width,
but I don't have other versions around to test/validate.
If that's the case then maybe we could add another STP state mask.
Signed-off-by: Alexandru Ardelean <ardeleanalex@gmail.com>
Signed-off-by: Jonas Gorski <jogo@openwrt.org>
SVN-Revision: 45937
|
|
|
|
|
|
| |
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45936
|
|
|
|
|
|
| |
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45935
|
|
|
|
|
|
| |
Signed-off-by: Jo-Philipp Wich <jow@openwrt.org>
SVN-Revision: 45934
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45933
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45932
|
|
|
|
|
|
|
|
|
| |
This allows e.g. BCM43602 to work out of box, without dumping a proper
MTD partition to /lib/firmware/ NVRAM file.
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45931
|
|
|
|
|
|
| |
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 45930
|
|
|
|
|
|
|
|
| |
This fixes #19803
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45929
|
|
|
|
|
|
|
|
|
| |
This adds support for SR400ac NVRAM and fixes
/sys/class/ieee80211/*/macaddress
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45928
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45927
|
|
|
|
|
|
| |
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45926
|
|
|
|
|
|
| |
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45925
|
|
|
|
|
|
| |
Signed-off-by: Steven Barth <steven@midlink.org>
SVN-Revision: 45924
|
|
|
|
|
|
|
|
| |
s/loclal/local/
Signed-off-by: Jonathan McCrohan <jmccrohan@gmail.com>
SVN-Revision: 45923
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45922
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45921
|
|
|
|
|
|
|
|
| |
being nuked by make kernel_oldconfig
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 45920
|
|
|
|
|
|
|
|
|
|
|
| |
They are useless, as the platform already selects the right options for
NAND support. The main reason for removing them is the fact that it
makes kernel configs more annoying to maintain on platforms that provide
NAND drivers but disable them (e.g. ramips)
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 45919
|
|
|
|
|
|
| |
Signed-off-by: John Crispin <blogic@openwrt.org>
SVN-Revision: 45918
|
|
|
|
|
|
| |
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
SVN-Revision: 45917
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45916
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45915
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45914
|
|
|
|
|
|
| |
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45913
|
|
|
|
|
|
|
|
|
| |
Extracting TRX to separated file in /tmp/ just wastes some RAM while we
can just pass a proper extracting command to the default_do_upgrade.
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45912
|
|
|
|
|
|
|
|
|
| |
Extracting full TRX out of vendor format is not needed as otrx supports
passing TRX offset. This saves some RAM during sysupgrade.
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
SVN-Revision: 45911
|