aboutsummaryrefslogtreecommitdiffstats
Commit message (Collapse)AuthorAgeFilesLines
* generic: rtl8367: allow to use VLANs > 31Gabor Juhos2012-05-271-0/+3
| | | | SVN-Revision: 31914
* move files-3.3 -> filesJohn Crispin2012-05-2729-0/+0
| | | | SVN-Revision: 31912
* 3.2 R.I.P.John Crispin2012-05-27111-70773/+0
| | | | SVN-Revision: 31911
* dgn3500 support with eeprom loading from sysfsJohn Crispin2012-05-272-27/+197
| | | | | | | | | | | | | | | | | WIFI eeprom: As discussed, it is impossible for nand and spi flash platforms to have the eeprom data available from mtd. I suggested to load the eeprom from user-space. I've looked into regular firmware loading but this is only possible when using modules. I've created a sysfs entry that allows reading and writing the eeprom data to the platform data. After loading the eeprom data I rely on pci-hotplug support to disable the bogus pci device and rescan the bus (with fixups and all). Because hotplug is not available, an init script is created that performs the copy from mtd to platform data. I think it is best to eventually move the sysfs functions to dev_wifi_athxk.c file, this would get rid of the external to the ath9k platform data. SPI flash: It seems that the spi-xway driver is not really working. It causes my kernel to crash in all sorts of ways. I added to bitbang SPI to be able to the calibration data mention above. I've kept the original mtd partitioning that Netgear uses. Buttons/LED: Both buttons are working properly. Two leds are not enabled: The red internet led is connected to the pci_gnt1 pin... I can't disable it because then DMA stops working. The green wifi led is connected to an unknown atheros gpio. Signed-off-by: Pieter Voorthuijsen <p.voorthuijsen at gmail.com> SVN-Revision: 31910
* fixes zyxel p2601hnfxJohn Crispin2012-05-271-26/+35
| | | | | | | | | moves the linux partition, removes the config partition and the buttons settings have small adjustments. Signed-off-by: Luka Perkov <openwrt@lukaperkov.net> SVN-Revision: 31909
* Add basic configuration for new board ZTE H201L. Still missing are button ↵John Crispin2012-05-277-3/+125
| | | | | | | | and led gpio values. Signed-off-by: Luka Perkov <openwrt@lukaperkov.net> SVN-Revision: 31908
* kernel: remove more unnecessary kernel version checks/dependenciesFelix Fietkau2012-05-277-83/+16
| | | | SVN-Revision: 31907
* kernel: properly pad the allocated headroom in skb_cow to NET_SKB_PADFelix Fietkau2012-05-271-1/+2
| | | | SVN-Revision: 31906
* linux/3.2: R.I.P.Gabor Juhos2012-05-27141-70858/+0
| | | | SVN-Revision: 31905
* xburst: remove support for old kernelsGabor Juhos2012-05-2754-24727/+0
| | | | SVN-Revision: 31904
* xburst: switch to 3.3 and add broken flagGabor Juhos2012-05-271-2/+2
| | | | SVN-Revision: 31903
* xburst: add support for 3.3Gabor Juhos2012-05-2726-0/+5408
| | | | SVN-Revision: 31902
* ppc44x: remove 3.2 supportGabor Juhos2012-05-273-264/+0
| | | | SVN-Revision: 31901
* ppx44x: switch to 3.3 and add broken flagGabor Juhos2012-05-271-2/+2
| | | | SVN-Revision: 31900
* ppc44x: add support for 3.3Gabor Juhos2012-05-273-0/+285
| | | | | | Compile tested only. SVN-Revision: 31899
* cobalt: switch to 3.3 and add broken flagGabor Juhos2012-05-272-6/+8
| | | | | | Compile tested only. SVN-Revision: 31898
* ep93xx: remove 3.2 supportGabor Juhos2012-05-274-1521/+0
| | | | SVN-Revision: 31897
* ep93xx: switch to 3.3 and add broken flagGabor Juhos2012-05-271-2/+2
| | | | SVN-Revision: 31896
* ep93xx: add support for 3.3Gabor Juhos2012-05-274-0/+1529
| | | | | | Compile tested only. SVN-Revision: 31895
* au1000: remove 3.2 supportGabor Juhos2012-05-274-312/+0
| | | | SVN-Revision: 31894
* au1000: switch to 3.3 and add broken flagGabor Juhos2012-05-271-2/+2
| | | | SVN-Revision: 31893
* au1000: add support for 3.3Gabor Juhos2012-05-274-0/+299
| | | | | | Compile tested only. SVN-Revision: 31892
* linux/3.1: R.I.P.Gabor Juhos2012-05-27128-71377/+0
| | | | SVN-Revision: 31891
* omap24xx: remove 3.1 supportGabor Juhos2012-05-2725-15609/+0
| | | | SVN-Revision: 31890
* omap24xx: switch to 3.3 and add broken flagGabor Juhos2012-05-271-2/+2
| | | | SVN-Revision: 31889
* cns3xxx: remove 3.1 supportGabor Juhos2012-05-2715-27496/+0
| | | | SVN-Revision: 31888
* cns3xxx: switch to 3.3 and add broken flagGabor Juhos2012-05-271-2/+2
| | | | SVN-Revision: 31887
* kernel: add a few patches for avoiding unnecessary skb reallocations - ↵Felix Fietkau2012-05-273-0/+59
| | | | | | significantly improves ethernet<->wireless performance with mac80211 based drivers SVN-Revision: 31886
* bcm63xx: build images for DSL-274XB revision F1Jonas Gorski2012-05-271-0/+3
| | | | | | | | | | | Build images for D-Link DSL-274XB revision F1. Flashing through original web UI as well as CFE works. Known issues: * wifi led inverted (on when wifi is off and vice cersa) * same issues as generic bcm6328 support SVN-Revision: 31885
* bcm63xx: add ath9k to atheros wifi profileJonas Gorski2012-05-271-1/+1
| | | | SVN-Revision: 31884
* bcm63xx: enable bcm6328 support and required driversJonas Gorski2012-05-271-3/+6
| | | | | | | | | | | BCM6328 support is in a usable state, with the following issues * internal switch port not configurable * external phys not supported * broadcom wifis will probably not work correctly * and all other generic bcm63xx issues (so yes, still no ADSL) SVN-Revision: 31883
* bcm63xx: add support for DSL-274XB rev F1Jonas Gorski2012-05-278-6/+146
| | | | SVN-Revision: 31882
* bcm63xx: fix port state after network downJonas Gorski2012-05-271-0/+28
| | | | | | | | bcm_enetsw_probe did not properly reset port states, resulting in connected ports staying disabled after bringing up the interface the second time. SVN-Revision: 31881
* bcm63xx: add a fixup for ath9k devicesJonas Gorski2012-05-2723-63/+1447
| | | | SVN-Revision: 31880
* bcm63xx: add support for the HSSPI controllerJonas Gorski2012-05-2733-55/+1241
| | | | | | | Add support for the HSSPI controller found on bcm6328 and SPI attached flash. SVN-Revision: 31879
* bcm63xx: add preliminary support for bcm6328Jonas Gorski2012-05-2721-18/+1364
| | | | SVN-Revision: 31878
* bcm63xx: add flash type detectionJonas Gorski2012-05-2732-80/+414
| | | | SVN-Revision: 31877
* bcm63xx: pad Speedport W303 V images to 4 MiBJonas Gorski2012-05-271-1/+1
| | | | | | | Prevents CFE from flashing to the second image offset. Fix up the rootfs length on first boot else CFE will complain. SVN-Revision: 31876
* tools: imagetag: add parameter for padding imagesJonas Gorski2012-05-274-2/+64
| | | | | | | Allow images to be padded to a certain size. This prevents CFE from flashing them to the second image offset. SVN-Revision: 31875
* bcm63xx: add a default switch configuration for DSL-274XBJonas Gorski2012-05-271-1/+6
| | | | SVN-Revision: 31874
* bcm63xx: setup network config through uci-defaultsJonas Gorski2012-05-2711-159/+42
| | | | SVN-Revision: 31873
* bcm63xx: move the board name workaround to /lib/brcm63xx.shJonas Gorski2012-05-272-8/+8
| | | | SVN-Revision: 31872
* bcm63xx: use the exact board id as board identification stringJonas Gorski2012-05-272-14/+17
| | | | | | No need to keep the bcm63xx/ at the start or the chipid info at the end. SVN-Revision: 31871
* kernel: remove a few more obsolete CompareKernelPatchVer calls, add ↵Felix Fietkau2012-05-277-169/+46
| | | | | | dependencies on @TARGET_x86 for a few network drivers that are typically not found in non-PC equipment SVN-Revision: 31870
* netifd: fix "Command failed: Not found" error with dhcpFelix Fietkau2012-05-261-1/+2
| | | | SVN-Revision: 31863
* mac80211: backport a fix for single-queue drivers (fixes #11534)Felix Fietkau2012-05-262-5/+17
| | | | SVN-Revision: 31862
* ncurses: libncursesw should not depend on libncursesFelix Fietkau2012-05-261-1/+0
| | | | SVN-Revision: 31861
* ppp: add back ip-{up,down}.d support for nowFelix Fietkau2012-05-262-0/+13
| | | | SVN-Revision: 31860
* mac80211: get rid of duplicate iw reg set command (thx, stintel)Felix Fietkau2012-05-261-1/+0
| | | | SVN-Revision: 31859
* netifd: update to latest version, fixes an endian issue in broadcast address ↵Felix Fietkau2012-05-251-2/+2
| | | | | | handling SVN-Revision: 31858
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-04 09:41:05 +0000