diff options
Diffstat (limited to 'target/linux/ipq806x/patches/0073-spi-qup-Get-rid-of-using-struct-spi_qup_device.patch')
| -rw-r--r-- | target/linux/ipq806x/patches/0073-spi-qup-Get-rid-of-using-struct-spi_qup_device.patch | 167 |
1 files changed, 167 insertions, 0 deletions
diff --git a/target/linux/ipq806x/patches/0073-spi-qup-Get-rid-of-using-struct-spi_qup_device.patch b/target/linux/ipq806x/patches/0073-spi-qup-Get-rid-of-using-struct-spi_qup_device.patch new file mode 100644 index 0000000000..69b4609a5f --- /dev/null +++ b/target/linux/ipq806x/patches/0073-spi-qup-Get-rid-of-using-struct-spi_qup_device.patch @@ -0,0 +1,167 @@ +From 3027505ab8c8cb17291e53bca1d7bd770539d468 Mon Sep 17 00:00:00 2001 +From: Axel Lin <axel.lin@ingics.com> +Date: Mon, 24 Feb 2014 23:07:36 +0800 +Subject: [PATCH 073/182] spi: qup: Get rid of using struct spi_qup_device + +Current code uses struct spi_qup_device to store spi->mode and spi->chip_select +settings. We can get these settings in spi_qup_transfer_one and spi_qup_set_cs +without using struct spi_qup_device. Refactor the code a bit to remove +spi_qup_setup(), spi_qup_cleanup(), and struct spi_qup_device. + +Signed-off-by: Axel Lin <axel.lin@ingics.com> +Tested-by: Ivan T. Ivanov <iivanov@mm-sol.com> +Signed-off-by: Mark Brown <broonie@linaro.org> +--- + drivers/spi/spi-qup.c | 61 ++++++++----------------------------------------- + 1 file changed, 9 insertions(+), 52 deletions(-) + +diff --git a/drivers/spi/spi-qup.c b/drivers/spi/spi-qup.c +index 203f0d4..b032e88 100644 +--- a/drivers/spi/spi-qup.c ++++ b/drivers/spi/spi-qup.c +@@ -123,11 +123,6 @@ + #define SPI_DELAY_THRESHOLD 1 + #define SPI_DELAY_RETRY 10 + +-struct spi_qup_device { +- int select; +- u16 mode; +-}; +- + struct spi_qup { + void __iomem *base; + struct device *dev; +@@ -338,14 +333,13 @@ static irqreturn_t spi_qup_qup_irq(int irq, void *dev_id) + + + /* set clock freq ... bits per word */ +-static int spi_qup_io_config(struct spi_qup *controller, +- struct spi_qup_device *chip, +- struct spi_transfer *xfer) ++static int spi_qup_io_config(struct spi_device *spi, struct spi_transfer *xfer) + { ++ struct spi_qup *controller = spi_master_get_devdata(spi->master); + u32 config, iomode, mode; + int ret, n_words, w_size; + +- if (chip->mode & SPI_LOOP && xfer->len > controller->in_fifo_sz) { ++ if (spi->mode & SPI_LOOP && xfer->len > controller->in_fifo_sz) { + dev_err(controller->dev, "too big size for loopback %d > %d\n", + xfer->len, controller->in_fifo_sz); + return -EIO; +@@ -399,12 +393,12 @@ static int spi_qup_io_config(struct spi_qup *controller, + + config = readl_relaxed(controller->base + SPI_CONFIG); + +- if (chip->mode & SPI_LOOP) ++ if (spi->mode & SPI_LOOP) + config |= SPI_CONFIG_LOOPBACK; + else + config &= ~SPI_CONFIG_LOOPBACK; + +- if (chip->mode & SPI_CPHA) ++ if (spi->mode & SPI_CPHA) + config &= ~SPI_CONFIG_INPUT_FIRST; + else + config |= SPI_CONFIG_INPUT_FIRST; +@@ -413,7 +407,7 @@ static int spi_qup_io_config(struct spi_qup *controller, + * HS_MODE improves signal stability for spi-clk high rates, + * but is invalid in loop back mode. + */ +- if ((xfer->speed_hz >= SPI_HS_MIN_RATE) && !(chip->mode & SPI_LOOP)) ++ if ((xfer->speed_hz >= SPI_HS_MIN_RATE) && !(spi->mode & SPI_LOOP)) + config |= SPI_CONFIG_HS_MODE; + else + config &= ~SPI_CONFIG_HS_MODE; +@@ -433,7 +427,6 @@ static int spi_qup_io_config(struct spi_qup *controller, + static void spi_qup_set_cs(struct spi_device *spi, bool enable) + { + struct spi_qup *controller = spi_master_get_devdata(spi->master); +- struct spi_qup_device *chip = spi_get_ctldata(spi); + + u32 iocontol, mask; + +@@ -444,9 +437,9 @@ static void spi_qup_set_cs(struct spi_device *spi, bool enable) + iocontol |= SPI_IO_C_FORCE_CS; + + iocontol &= ~SPI_IO_C_CS_SELECT_MASK; +- iocontol |= SPI_IO_C_CS_SELECT(chip->select); ++ iocontol |= SPI_IO_C_CS_SELECT(spi->chip_select); + +- mask = SPI_IO_C_CS_N_POLARITY_0 << chip->select; ++ mask = SPI_IO_C_CS_N_POLARITY_0 << spi->chip_select; + + if (enable) + iocontol |= mask; +@@ -461,11 +454,10 @@ static int spi_qup_transfer_one(struct spi_master *master, + struct spi_transfer *xfer) + { + struct spi_qup *controller = spi_master_get_devdata(master); +- struct spi_qup_device *chip = spi_get_ctldata(spi); + unsigned long timeout, flags; + int ret = -EIO; + +- ret = spi_qup_io_config(controller, chip, xfer); ++ ret = spi_qup_io_config(spi, xfer); + if (ret) + return ret; + +@@ -511,38 +503,6 @@ exit: + return ret; + } + +-static int spi_qup_setup(struct spi_device *spi) +-{ +- struct spi_qup *controller = spi_master_get_devdata(spi->master); +- struct spi_qup_device *chip = spi_get_ctldata(spi); +- +- if (!chip) { +- /* First setup */ +- chip = kzalloc(sizeof(*chip), GFP_KERNEL); +- if (!chip) { +- dev_err(controller->dev, "no memory for chip data\n"); +- return -ENOMEM; +- } +- +- chip->mode = spi->mode; +- chip->select = spi->chip_select; +- spi_set_ctldata(spi, chip); +- } +- +- return 0; +-} +- +-static void spi_qup_cleanup(struct spi_device *spi) +-{ +- struct spi_qup_device *chip = spi_get_ctldata(spi); +- +- if (!chip) +- return; +- +- spi_set_ctldata(spi, NULL); +- kfree(chip); +-} +- + static int spi_qup_probe(struct platform_device *pdev) + { + struct spi_master *master; +@@ -561,7 +521,6 @@ static int spi_qup_probe(struct platform_device *pdev) + return PTR_ERR(base); + + irq = platform_get_irq(pdev, 0); +- + if (irq < 0) + return irq; + +@@ -617,8 +576,6 @@ static int spi_qup_probe(struct platform_device *pdev) + master->num_chipselect = SPI_NUM_CHIPSELECTS; + master->bits_per_word_mask = SPI_BPW_RANGE_MASK(4, 32); + master->max_speed_hz = max_freq; +- master->setup = spi_qup_setup; +- master->cleanup = spi_qup_cleanup; + master->set_cs = spi_qup_set_cs; + master->transfer_one = spi_qup_transfer_one; + master->dev.of_node = pdev->dev.of_node; +-- +1.7.10.4 + |