diff options
author | INAGAKI Hiroshi <musashino.open@gmail.com> | 2019-07-11 14:41:08 +0900 |
---|---|---|
committer | Chuanhong Guo <gch981213@gmail.com> | 2019-09-25 14:44:36 +0800 |
commit | 12ab6ef5c377e9d4aa8f0758ca92056da7eea0bf (patch) | |
tree | 8b00dfdb3e70fc5240b5088c8a0677cc34087d7e /target | |
parent | c1394dabf6547dbc25e9563ef980aed9589479ab (diff) | |
download | upstream-12ab6ef5c377e9d4aa8f0758ca92056da7eea0bf.tar.gz upstream-12ab6ef5c377e9d4aa8f0758ca92056da7eea0bf.tar.bz2 upstream-12ab6ef5c377e9d4aa8f0758ca92056da7eea0bf.zip |
ramips: add support for I-O DATA WNPR2600G
I-O DATA WNPR2600G is a 2.4/5 GHz band 11ac router, based on MediaTek
MT7621A.
Specification:
- SoC : MediaTek MT7621A
- RAM : DDR3 128 MiB
- Flash : SPI-NOR 16 MiB
- WLAN : 2.4/5 GHz 4T4R
- 2.4 GHz : MediaTek MT7615
- 5 GHz : MediaTek MT7615
- Ethernet : 10/100/1000 Mbps
- Switch : MT7530 (SoC)
- LED/keys : 4x/3x (2x buttons, 1x slide-switch)
- UART : through-hole on PCB
- J1: Vcc, RX, GND, TX from SoC side
- 57600n8
Flash instruction using factory image:
1. Boot WNPR2600G normaly
2. Access to "http://192.168.0.1/" and open firmware update page
("ファームウェア")
3. Select the OpenWrt factory image and click update ("更新") button
to perform firmware update
4. Wait ~150 seconds to complete flashing
Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com>
Diffstat (limited to 'target')
-rwxr-xr-x | target/linux/ramips/base-files/etc/board.d/02_network | 5 | ||||
-rw-r--r-- | target/linux/ramips/dts/mt7621_iodata_wnpr2600g.dts | 165 | ||||
-rw-r--r-- | target/linux/ramips/image/mt7621.mk | 13 |
3 files changed, 183 insertions, 0 deletions
diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network index 981d6c2596..d485010e3a 100755 --- a/target/linux/ramips/base-files/etc/board.d/02_network +++ b/target/linux/ramips/base-files/etc/board.d/02_network @@ -242,6 +242,7 @@ ramips_setup_interfaces() huawei,hg255d|\ iodata,wn-ax1167gr|\ iodata,wn-gx300gr|\ + iodata,wnpr2600g|\ iptime,a604m) ucidef_add_switch "switch0" \ "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "0:wan" "6@eth0" @@ -670,6 +671,10 @@ ramips_setup_macs() trendnet,tew-692gr) wan_mac=$(macaddr_add "$(mtd_get_mac_binary factory 0x4)" 1) ;; + iodata,wnpr2600g) + wan_mac=$(mtd_get_mac_ascii u-boot-env wanaddr) + label_mac=$wan_mac + ;; iptime,a3|\ iptime,a604m) wan_mac=$(mtd_get_mac_binary u-boot 0x1fc40) diff --git a/target/linux/ramips/dts/mt7621_iodata_wnpr2600g.dts b/target/linux/ramips/dts/mt7621_iodata_wnpr2600g.dts new file mode 100644 index 0000000000..09bc9a3d56 --- /dev/null +++ b/target/linux/ramips/dts/mt7621_iodata_wnpr2600g.dts @@ -0,0 +1,165 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include "mt7621.dtsi" + +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> + +/ { + compatible = "iodata,wnpr2600g", "mediatek,mt7621-soc"; + model = "I-O DATA WNPR2600G"; + + aliases { + led-boot = &led_power; + led-failsafe = &led_power; + led-running = &led_power; + led-upgrade = &led_power; + }; + + chosen { + bootargs = "console=ttyS0,57600"; + }; + + leds { + compatible = "gpio-leds"; + + led_power: power { + label = "wnpr2600g:green:power"; + gpios = <&gpio0 7 GPIO_ACTIVE_HIGH>; + default-state = "on"; + }; + + notification { + label = "wnpr2600g:green:notification"; + gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>; + }; + + wlan2g { + label = "wnpr2600g:green:wlan2g"; + gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>; + linux,default-trigger = "phy0radio"; + }; + + wlan5g { + label = "wnpr2600g:green:wlan5g"; + gpios = <&gpio0 15 GPIO_ACTIVE_HIGH>; + linux,default-trigger = "phy1radio"; + }; + }; + + keys { + compatible = "gpio-keys"; + + auto { + label = "auto"; + gpios = <&gpio0 13 GPIO_ACTIVE_LOW>; + linux,code = <BTN_0>; + linux,input-type = <EV_SW>; + }; + + reset { + label = "reset"; + gpios = <&gpio0 16 GPIO_ACTIVE_LOW>; + linux,code = <KEY_RESTART>; + }; + + wps { + label = "wps"; + gpios = <&gpio0 18 GPIO_ACTIVE_LOW>; + linux,code = <KEY_WPS_BUTTON>; + }; + }; +}; + +&spi0 { + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <40000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x000000 0x030000>; + read-only; + }; + + partition@30000 { + label = "u-boot-env"; + reg = <0x030000 0x010000>; + read-only; + }; + + factory: partition@40000 { + label = "factory"; + reg = <0x040000 0x010000>; + read-only; + }; + + partition@50000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x050000 0xda0000>; + }; + + partition@df0000 { + label = "manufacture"; + reg = <0xdf0000 0x190000>; + read-only; + }; + + partition@f80000 { + label = "storage"; + reg = <0xf80000 0x080000>; + read-only; + }; + }; + }; +}; + +ðernet { + mtd-mac-address = <&factory 0x4>; + mediatek,portmap = "wllll"; +}; + +&pinctrl { + state_default: pinctrl0 { + gpio { + ralink,group = "uart2", "uart3", "jtag", "wdt"; + ralink,function = "gpio"; + }; + }; +}; + +&pcie { + status = "okay"; +}; + +&pcie0 { + wifi@0,0 { + compatible = "mediatek,mt76"; + reg = <0x0000 0 0 0 0>; + mediatek,mtd-eeprom = <&factory 0x0>; + ieee80211-freq-limit = <2400000 2500000>; + }; +}; + +&pcie1 { + wifi@0,0 { + compatible = "mediatek,mt76"; + reg = <0x0000 0 0 0 0>; + mediatek,mtd-eeprom = <&factory 0x8000>; + ieee80211-freq-limit = <5000000 6000000>; + }; +}; + +&xhci { + status = "disabled"; +}; diff --git a/target/linux/ramips/image/mt7621.mk b/target/linux/ramips/image/mt7621.mk index 4cf9cf7ff2..816652ddaa 100644 --- a/target/linux/ramips/image/mt7621.mk +++ b/target/linux/ramips/image/mt7621.mk @@ -322,6 +322,19 @@ define Device/iodata_wn-gx300gr endef TARGET_DEVICES += iodata_wn-gx300gr +define Device/iodata_wnpr2600g + MTK_SOC := mt7621 + DEVICE_VENDOR := I-O DATA + DEVICE_MODEL := WNPR2600G + IMAGE_SIZE := 13952k + IMAGES += factory.bin + IMAGE/factory.bin := \ + $$(sysupgrade_bin) | check-size $$$$(IMAGE_SIZE) | \ + elx-header 0104003a 8844A2D168B45A2D + DEVICE_PACKAGES := kmod-mt7615e wpad-basic +endef +TARGET_DEVICES += iodata_wnpr2600g + define Device/lenovo_newifi-d1 MTK_SOC := mt7621 IMAGE_SIZE := 32448k |