diff options
author | Robert Marko <robimarko@gmail.com> | 2017-11-14 12:15:03 +0100 |
---|---|---|
committer | Piotr Dymacz <pepe2k@gmail.com> | 2017-11-14 22:36:46 +0100 |
commit | ac4a52b5c80fd877503251a299f7ca6f1cc394e6 (patch) | |
tree | 331bb14f74c6ed53073304b9db7b1623b89f84da /target/linux/zynq/base-files.mk | |
parent | d7adaceda33b0b94962477e4c06c04d1ea4e82f8 (diff) | |
download | upstream-ac4a52b5c80fd877503251a299f7ca6f1cc394e6.tar.gz upstream-ac4a52b5c80fd877503251a299f7ca6f1cc394e6.tar.bz2 upstream-ac4a52b5c80fd877503251a299f7ca6f1cc394e6.zip |
ar71xx: complete support for RB mAP 2nD
This patch adds support for the MikroTik RouterBOARD mAP 2nD
https://mikrotik.com/product/RBmAP2nD
Specifications:
- SoC: Qualcomm QCA9531 (650 MHz)
- RAM: 64 MB
- Storage: 16 MB NOR SPI flash
- Wireless: builtin QCA9531, 2x2:2
- Ethernet: 2x100M (802.3af/at POE in and passive POE out on ETH2)
- USB: microUSB type AB port
This patch adds missing code to fully support mAP. Machfile already
contained configuration for mAP 2nD, but device specific configuration
like LEDs etc., was missing.
Note: The POE LED works but doesn't turn on when POE passthrough is
enabled, despite being configured with GPIO trigger.
Installation
1. Login to the Mikrotik WebUI to backup your licence keys
2. Setup a DHCP/BOOTP server with:
- DHCP-Option 66 (TFTP server name) pointing to a local TFTP
server within the same subnet of the DHCP range
- DHCP-Option 67 (Bootfile-Name) matching the initramfs filename
of the to be booted image
3. Connect the port labeled internet to your local network
4. Keep the reset button pushed down and power on the board
The board should load and start the initramfs image from the TFTP
server. Login as root/without password to the started LEDE via SSH
listing on IPv4 address 192.168.1.1. Use sysupgrade to install LEDE.
Revert to RouterOS
Use the "rbcfg" package on in LEDE:
- rbcfg set boot_protocol bootp
- rbcfg set boot_device ethnand
- rbcfg apply
Open Netinstall and reboot routerboard. Now Netinstall sees RouterBOARD
and you can install RouterOS. If NetInstall gets stuck on Sending offer
just wait for it to timeout and then close and open Netinstall again.
Click on install again.
In order for RouterOS to function properly, you need to restore license
for the device. You can do that by including license in NetInstall.
Signed-off-by: Robert Marko <robimarko@gmail.com>
Diffstat (limited to 'target/linux/zynq/base-files.mk')
0 files changed, 0 insertions, 0 deletions