diff options
author | Abdul Aziz Amar <abdulaziz.amar@gmail.com> | 2022-03-14 05:26:23 -0400 |
---|---|---|
committer | Hauke Mehrtens <hauke@hauke-m.de> | 2022-04-16 14:02:11 +0200 |
commit | 78c3534645958c123aa82cec9926a34eed5dd5dd (patch) | |
tree | a7790800fa9bff034eef41290946c80e8c20efd6 /target/linux/ramips/mt7621/base-files/etc/board.d/02_network | |
parent | bb505d82add5636da891bb97fdabc57947280e88 (diff) | |
download | upstream-78c3534645958c123aa82cec9926a34eed5dd5dd.tar.gz upstream-78c3534645958c123aa82cec9926a34eed5dd5dd.tar.bz2 upstream-78c3534645958c123aa82cec9926a34eed5dd5dd.zip |
ramips: add support for BOLT! Arion
This device is from now-defunct BOLT! ISP in Indonesia.
The original firmware is based on mediatek SDK running linux 2.6 or 3.x in later revision.
Specifications:
- SoC: MediaTek MT7621
- Flash: 32 MiB NOR SPI
- RAM: 128 MiB DDR3
- Ethernet: 2x 10/100/1000 Mbps (switched, LAN + WAN)
- WIFI0: MT7603E 2.4GHz 802.11b/g/n
- WIFI1: MT7612E 5GHz 802.11ac
- Antennas: 2x internal, non-detachable
- LEDs: Programmable LEDs: 5 blue LEDs (wlan, tel, sig1-3) and 2 red LEDs (wlan and sig1)
Non-programmable "Power" LED
- Buttons: Reset and WPS
Instalation:
Install from TFTP
Set your PC IP to 10.10.10.3 and gateway to 10.10.10.123
Press "1" when turning on the router, and type the initramfs file name
You also need to solder pin header or cable to J4 or neighboring test points (T19-T21)
Pinouts from top to bottom: GND, TX, RX, VCC (3.3v)
Baudrate: 57600n8
There's also an additional gigabit transformer and RTL8211FD managed by the LTE module on the backside of the PCB.
Signed-off-by: Abdul Aziz Amar <abdulaziz.amar@gmail.com>
Diffstat (limited to 'target/linux/ramips/mt7621/base-files/etc/board.d/02_network')
-rw-r--r-- | target/linux/ramips/mt7621/base-files/etc/board.d/02_network | 7 |
1 files changed, 7 insertions, 0 deletions
diff --git a/target/linux/ramips/mt7621/base-files/etc/board.d/02_network b/target/linux/ramips/mt7621/base-files/etc/board.d/02_network index 1fc0ccdd5b..7223908f95 100644 --- a/target/linux/ramips/mt7621/base-files/etc/board.d/02_network +++ b/target/linux/ramips/mt7621/base-files/etc/board.d/02_network @@ -51,6 +51,13 @@ ramips_setup_interfaces() xiaomi,mi-router-4a-gigabit) ucidef_set_interfaces_lan_wan "lan1 lan2" "wan" ;; + bolt,arion) + ucidef_set_interfaces_lan_wan "lan" "wan" + ucidef_set_interface "eth_data" device "modem.103" protocol "static" ipaddr "10.22.127.222" netmask "255.255.255.255" + ucidef_set_interface "eth_om" device "modem.4094" protocol "static" ipaddr "169.254.0.2" netmask "255.255.255.252" + uci add_list firewall.@zone[1].network='eth_data' + uci add_list firewall.@zone[1].network='eth_om' + ;; gnubee,gb-pc1|\ gnubee,gb-pc2) ucidef_set_interface_lan "lan1 lan2" |