diff options
author | Piotr Dymacz <pepe2k@gmail.com> | 2022-02-17 23:22:25 +0100 |
---|---|---|
committer | Piotr Dymacz <pepe2k@gmail.com> | 2022-02-27 16:54:54 +0100 |
commit | 131671bc54dff89c33c10241b8fca8fa34a9b2bf (patch) | |
tree | 1ede76b4dfe411e27a4fb2e9b253248bb582eb52 /target/linux/ath79/generic/base-files/etc | |
parent | 53ac6ee552baca52f3f18fc95b793c03e1bf9581 (diff) | |
download | upstream-131671bc54dff89c33c10241b8fca8fa34a9b2bf.tar.gz upstream-131671bc54dff89c33c10241b8fca8fa34a9b2bf.tar.bz2 upstream-131671bc54dff89c33c10241b8fca8fa34a9b2bf.zip |
ath79: add support for ALFA Network Tube-2HQ
ALFA Network Tube-2HQ is a successor of the Tube-2H/P series (EOL) which
was based on the Atheros AR9331. The new version uses Qualcomm QCA9531.
Specifications:
- Qualcomm/Atheros QCA9531 v2
- 650/400/200 MHz (CPU/DDR/AHB)
- 64 or 128 MB of RAM (DDR2)
- 16+ MB of flash (SPI NOR)
- 1x 10/100 Mbps Ethernet with passive PoE input (24 V)
(802.3at/af PoE support with optional module)
- 1T1R 2.4 GHz Wi-Fi with external PA (SE2623L, up to 27 dBm) and LNA
- 1x Type-N (male) antenna connector
- 6x LED (5x driven by GPIO)
- 1x button (reset)
- external h/w watchdog (EM6324QYSP5B, enabled by default)
- UART (4-pin, 2.00 mm pitch) header on PCB
Flash instruction:
You can use sysupgrade image directly in vendor firmware which is based
on LEDE/OpenWrt. Alternatively, you can use web recovery mode in U-Boot:
1. Configure PC with static IP 192.168.1.2/24.
2. Connect PC with one of RJ45 ports, press the reset button, power up
device, wait for first blink of all LEDs (indicates network setup),
then keep button for 3 following blinks and release it.
3. Open 192.168.1.1 address in your browser and upload sysupgrade image.
Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>
Diffstat (limited to 'target/linux/ath79/generic/base-files/etc')
-rw-r--r-- | target/linux/ath79/generic/base-files/etc/board.d/01_leds | 8 | ||||
-rw-r--r-- | target/linux/ath79/generic/base-files/etc/board.d/02_network | 2 |
2 files changed, 10 insertions, 0 deletions
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds index 18904f8528..354df1da6f 100644 --- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds @@ -48,6 +48,14 @@ alfa-network,r36a) ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0" ucidef_set_led_switch "wan" "WAN" "blue:wan" "switch0" "0x10" ;; +alfa-network,tube-2hq) + ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0" + ucidef_set_rssimon "wlan0" "200000" "1" + ucidef_set_led_rssi "signal1" "SIGNAL1" "red:signal1" "wlan0" "1" "100" + ucidef_set_led_rssi "signal2" "SIGNAL2" "orange:signal2" "wlan0" "25" "100" + ucidef_set_led_rssi "signal3" "SIGNAL3" "green:signal3" "wlan0" "50" "100" + ucidef_set_led_rssi "signal4" "SIGNAL4" "green:signal4" "wlan0" "75" "100" + ;; asus,rp-ac66) ucidef_set_rssimon "wlan0" "200000" "1" ucidef_set_rssimon "wlan1" "200000" "1" diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network index 447d1cdea2..bb5c63a33e 100644 --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network @@ -13,6 +13,7 @@ ath79_setup_interfaces() allnet,all-wap02860ac|\ alfa-network,ap121f|\ alfa-network,pi-wifi4|\ + alfa-network,tube-2hq|\ arduino,yun|\ aruba,ap-105|\ asus,rp-ac66|\ @@ -529,6 +530,7 @@ ath79_setup_macs() alfa-network,n5q|\ alfa-network,pi-wifi4|\ alfa-network,r36a|\ + alfa-network,tube-2hq|\ engenius,eap300-v2|\ engenius,ens202ext-v1) label_mac=$(mtd_get_mac_binary art 0x1002) |