diff options
| author | Michal Cieslakiewicz <michal.cieslakiewicz@wp.pl> | 2019-10-16 12:42:44 +0200 |
|---|---|---|
| committer | John Crispin <john@phrozen.org> | 2019-10-21 13:15:46 +0200 |
| commit | 09f46c6b541b2db1b16d03176f10f7ff589713c4 (patch) | |
| tree | 61fa1b5208d1a0822e9f0eaeb0085b10886a5d24 /target/linux/ath79/base-files/etc | |
| parent | 12719ce37a0782a2e7b816020cdfca1973d5bc01 (diff) | |
| download | upstream-09f46c6b541b2db1b16d03176f10f7ff589713c4.tar.gz upstream-09f46c6b541b2db1b16d03176f10f7ff589713c4.tar.bz2 upstream-09f46c6b541b2db1b16d03176f10f7ff589713c4.zip | |
ath79: add support for Netgear WNR1000 v2
This patch adds ath79 support for Netgear WNR1000v2.
Router was previously supported by ar71xx target only.
Note: this is a 4_32 device with limited upgrade capabilities.
Specification
=============
* Description: Netgear WNR1000 v2
* Loader: U-boot
* SOC: Atheros AR7240 (340 MHz)
* RAM: 32 MiB
* Flash: 4 MiB (SPI NOR)
- U-boot binary: 256 KiB
- U-boot environment: 64 KiB
- Firmware: 3712 KiB
- ART: 64 KiB
* Ethernet: 4 x 10/100 LAN + 1 x 10/100 WAN
* Wireless: 2.4 GHz b/g/n (Atheros AR9285)
* USB: no
* Buttons:
- Reset
- WiFi (rfkill)
- WPS
* LEDs:
- Power (amber/green)
- WAN (amber/green)
- WLAN (blue)
- 4 x LAN (amber/green)
- WPS (green)
* UART: 4-pin connector JP2, 3.3V (Vcc, TX, RX, GND), 115200 8N1
* Power supply: DC 12V 1A
* MAC addresses: LAN on case label, WAN +1, WLAN +2
Installation
============
* TFTP recovery
* TFTP via U-boot prompt
* sysupgrade
* Web interface
Test build configuration
========================
CONFIG_TARGET_ath79=y
CONFIG_TARGET_ath79_tiny=y
CONFIG_TARGET_ath79_tiny_DEVICE_netgear_wnr1000-v2=y
CONFIG_ALL_KMODS=y
CONFIG_DEVEL=y
CONFIG_CCACHE=y
CONFIG_COLLECT_KERNEL_DEBUG=y
CONFIG_IMAGEOPT=y
CONFIG_KERNEL_DEBUG_INFO=y
CONFIG_KERNEL_DEBUG_KERNEL=y
Signed-off-by: Michal Cieslakiewicz <michal.cieslakiewicz@wp.pl>
Diffstat (limited to 'target/linux/ath79/base-files/etc')
3 files changed, 3 insertions, 0 deletions
diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds index 97598ce45c..499fe0031c 100755 --- a/target/linux/ath79/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/base-files/etc/board.d/01_leds @@ -111,6 +111,7 @@ glinet,gl-ar300m-lite) glinet,gl-x750) ucidef_set_led_netdev "wan" "WAN" "$boardname:green:wan" "eth1" ;; +netgear,wnr1000-v2|\ netgear,wnr2000-v3) ucidef_set_led_netdev "wan-amber" "WAN (amber)" "netgear:amber:wan" "eth0" ucidef_set_led_switch "lan1green" "LAN1 (green)" "netgear:green:lan1" "switch0" "0x02" "0x04" diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 5b50a6270b..c40c07a906 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -205,6 +205,7 @@ ath79_setup_interfaces() ucidef_add_switch_port_attr "switch0" 2 led 9 ucidef_add_switch_port_attr "switch0" 5 led 2 ;; + netgear,wnr1000-v2|\ netgear,wnr2000-v3|\ netgear,wnr612-v2|\ on,n150r|\ diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom index 96b4fb0f8a..2d760e2091 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom @@ -79,6 +79,7 @@ case "$FIRMWARE" in winchannel,wb2000) caldata_extract "art" 0x5000 0x440 ;; + netgear,wnr1000-v2|\ netgear,wnr2000-v3|\ netgear,wnr612-v2|\ on,n150r|\ |