diff options
| author | Andreas Böhler <dev@aboehler.at> | 2023-04-29 20:48:47 +0200 |
|---|---|---|
| committer | Hauke Mehrtens <hauke@hauke-m.de> | 2023-05-06 20:59:46 +0200 |
| commit | 590d1fd0e636f627bbfeb988909ec36cc5450a3b (patch) | |
| tree | cb54b71f67d1f88d151b2b7ba13a57a6850c2034 /target/Config.in | |
| parent | 8bc4aaf45cee578f6e527b1582d0dcf065dc81c8 (diff) | |
| download | upstream-590d1fd0e636f627bbfeb988909ec36cc5450a3b.tar.gz upstream-590d1fd0e636f627bbfeb988909ec36cc5450a3b.tar.bz2 upstream-590d1fd0e636f627bbfeb988909ec36cc5450a3b.zip | |
ath79: add support for ZTE MF282
The ZTE MF282 is a LTE router used (exclusively?) by the network operator
"3".
Specifications
==============
SoC: QCA9563 (775MHz)
RAM: 128MiB
Flash: 8MiB SPI-NOR + 128MiB SPI-NAND
LAN: 1x GBit LAN
LTE: ZTE MF270 (Cat4), detected as P685M
WiFi: QCA9880ac + QCA9560bgn
MAC addresses
=============
LAN: from config
WiFi 1: from config
WiFi 2: +1
Installation
============
TFTP installation using UART is preferred. Disassemble the device and
connect serial. Put the initramfs image as openwrt.bin to your TFTP server
and configure a static IP of 192.168.1.100. Load the initramfs image by
typing:
setenv serverip 192.168.1.100
setenv ipaddr 192.168.1.1
tftpboot 0x82000000 openwrt.bin
bootm 0x82000000
From this intiramfs boot you can take a backup of the currently installed
partitions as no vendor firmware is available for download.
Once booted, transfer the sysupgrade image and run sysupgrade.
LTE Modem
=========
The LTE modem is probably the same as in the MF283+, all instructions
apply.
Configuring the connection using modemmanager works properly, the modem
provides three serial ports and a QMI CDC ethernet interface.
Signed-off-by: Andreas Böhler <dev@aboehler.at>
Diffstat (limited to 'target/Config.in')
0 files changed, 0 insertions, 0 deletions