diff options
author | Marek Lindner <marek.lindner@kaiwoo.ai> | 2018-11-25 21:46:54 +0800 |
---|---|---|
committer | Petr Štetiar <ynezz@true.cz> | 2020-12-22 19:11:50 +0100 |
commit | ea5bb6bbfee06f44f714aff40c8929505face221 (patch) | |
tree | c3ae619246530a997fffbc38ffde4a2e80b357e7 /scripts/gen_image_generic.sh | |
parent | 8a891bfaa01d9592ea86c6b0cbbd5c04688c09f8 (diff) | |
download | upstream-ea5bb6bbfee06f44f714aff40c8929505face221.tar.gz upstream-ea5bb6bbfee06f44f714aff40c8929505face221.tar.bz2 upstream-ea5bb6bbfee06f44f714aff40c8929505face221.zip |
ipq40xx: add support for Plasma Cloud PA1200
Device specifications:
* QCA IPQ4018
* 256 MB of RAM
* 32 MB of SPI NOR flash (w25q256)
- 2x 15 MB available; but one of the 15 MB regions is the recovery image
* 2T2R 2.4 GHz
- QCA4019 hw1.0 (SoC)
- requires special BDF in QCA4019/hw1.0/board-2.bin with
bus=ahb,bmi-chip-id=0,bmi-board-id=16,variant=PlasmaCloud-PA1200
* 2T2R 5 GHz
- QCA4019 hw1.0 (SoC)
- requires special BDF in QCA4019/hw1.0/board-2.bin with
bus=ahb,bmi-chip-id=0,bmi-board-id=17,variant=PlasmaCloud-PA1200
* 3x GPIO-LEDs for status (cyan, purple, yellow)
* 1x GPIO-button (reset)
* 1x USB (xHCI)
* TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX)
* 2x gigabit ethernet
- phy@mdio4:
+ Label: Ethernet 1
+ gmac0 (ethaddr) in original firmware
+ used as LAN interface
- phy@mdio3:
+ Label: Ethernet 2
+ gmac1 (eth1addr) in original firmware
+ 802.3af/at POE(+)
+ used as WAN interface
* 12V/24V 1A DC
Flashing instructions:
The tool ap51-flash (https://github.com/ap51-flash/ap51-flash) should be
used to transfer the factory image to the u-boot when the device boots up.
Signed-off-by: Marek Lindner <marek.lindner@kaiwoo.ai>
[sven@narfation.org: prepare commit message, rebase, use all LEDs, switch
to dualboot_datachk upgrade script, use eth1 as designated WAN interface]
Signed-off-by: Sven Eckelmann <sven@narfation.org>
Diffstat (limited to 'scripts/gen_image_generic.sh')
0 files changed, 0 insertions, 0 deletions