diff options
| author | INAGAKI Hiroshi <musashino.open@gmail.com> | 2019-03-16 13:27:32 +0900 |
|---|---|---|
| committer | Christian Lamparter <chunkeey@gmail.com> | 2019-04-06 19:14:06 +0200 |
| commit | 643fcfc8d64563d6c581a899ff839c9a91432e98 (patch) | |
| tree | 52c375338d37c21dcf61c80977666f9052ac119d /package | |
| parent | fac27643f057d681ec276828dc4d1ba7159b5680 (diff) | |
| download | upstream-643fcfc8d64563d6c581a899ff839c9a91432e98.tar.gz upstream-643fcfc8d64563d6c581a899ff839c9a91432e98.tar.bz2 upstream-643fcfc8d64563d6c581a899ff839c9a91432e98.zip | |
ath79: add support for NEC Aterm WG1200CR
NEC Aterm WG1200CR is a 2.4/5 GHz band 11ac router,
based on Qualcomm Atheros QCA9563.
Specification:
- SoC : Qualcomm Atheros QCA9563
- RAM : DDR2 128 MiB
- Flash : SPI-NOR 8 MiB
- WLAN : 2.4/5 GHz 2T2R
- 2.4 GHz : QCA9563 (SoC)
- 5 GHz : QCA9888
- Ethernet : 2x 10/100/1000 Mbps
- Switch : QCA8334
- LEDs/Input : 12x/4x (2x buttons, 1x slide-switch)
- UART : through-hole on PCB
- JP1: Vcc, GND, NC, TX, RX from power connector side
- 115200 bps
Flash instruction using factory image:
1. Boot WG1200CR normaly
2. Access to "http://192.168.10.1/" and open firmware update page
("ファームウェア更新")
3. Select the OpenWrt factory image and click update ("更新") button
to perform firmware update
4. Wait ~150 seconds to complete flashing
Known issues:
- cannot be controlled LEDs other than Power (Green/Red)
- only Power LEDs are connected to SoC GPIO; other LEDs
connected to the gpiochip on ath10k chip (QCA9888)
Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com>
Signed-off-by: Christian Lamparter <chunkeey@gmail.com> [commit
message formatting]
Diffstat (limited to 'package')
0 files changed, 0 insertions, 0 deletions