(6/6) bcm57xx: package

This is the bcm57xx package.  I have tested default vlan functions,
but I dont have the equipment to test more advanced setups.  The default
vlan setup seems to be working fine.  I also added the activate_gpio
parameter which will make the driver activate the switch via gpio before
probing for it.

I'm not sure which method is best for autoload.  For the wrt350n, I
need the activate_gpio parameter.  But its probably not a good idea
to add that to the autoload file.  On a system without a bcm57xx switch,
isn't it a bad idea to mess with the gpios looking for the switch? Ideally,
wouldn't it be best to load the bcm57xx module from broadcom-diag, after
it has determined which router its on?  I tried using 'request_module' from
there, but had no success.  For now, I am relying on preinit to load
the bcm57xx module with activate_gpio param, after it has failed to load
switch_robo and switch_adm.

Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>

SVN-Revision: 11471

1 files changed, 48 insertions, 0 deletions

diff --git a/package/broadcom-57xx/src/proto/bcmudp.h b/package/broadcom-57xx/src/proto/bcmudp.h
new file mode 100644
index 0000000000..782f12e219
--- /dev/null
+++ b/package/broadcom-57xx/src/proto/bcmudp.h
@@ -0,0 +1,48 @@
+/*
+ * Copyright 2007, Broadcom Corporation
+ * All Rights Reserved.                
+ *                                     
+ * This is UNPUBLISHED PROPRIETARY SOURCE CODE of Broadcom Corporation;   
+ * the contents of this file may not be disclosed to third parties, copied
+ * or duplicated in any form, in whole or in part, without the prior      
+ * written permission of Broadcom Corporation.                            
+ *
+ * Fundamental constants relating to UDP Protocol
+ *
+ * $Id: bcmudp.h,v 1.1.1.1 2007/05/31 08:00:41 michael Exp $
+ */
+
+#ifndef _bcmudp_h_
+#define _bcmudp_h_
+
+/* enable structure packing */
+#if defined(__GNUC__)
+#define	PACKED	__attribute__((packed))
+#else
+#pragma pack(1)
+#define	PACKED
+#endif
+
+/* UDP header */
+#define UDP_DEST_PORT_OFFSET	2	/* UDP dest port offset */
+#define UDP_LEN_OFFSET		4	/* UDP length offset */
+#define UDP_CHKSUM_OFFSET	6	/* UDP body checksum offset */
+
+#define UDP_HDR_LEN	8	/* UDP header length */
+#define UDP_PORT_LEN	2	/* UDP port length */
+
+/* These fields are stored in network order */
+struct bcmudp_hdr
+{
+	uint16	src_port;	/* Source Port Address */
+	uint16	dst_port;	/* Destination Port Address */
+	uint16	len;		/* Number of bytes in datagram including header */
+	uint16	chksum;		/* entire datagram checksum with pseudoheader */
+} PACKED;
+
+#undef PACKED
+#if !defined(__GNUC__)
+#pragma pack()
+#endif
+
+#endif	/* #ifndef _bcmudp_h_ */