(6/6) bcm57xx: package

This is the bcm57xx package.  I have tested default vlan functions,
but I dont have the equipment to test more advanced setups.  The default
vlan setup seems to be working fine.  I also added the activate_gpio
parameter which will make the driver activate the switch via gpio before
probing for it.

I'm not sure which method is best for autoload.  For the wrt350n, I
need the activate_gpio parameter.  But its probably not a good idea
to add that to the autoload file.  On a system without a bcm57xx switch,
isn't it a bad idea to mess with the gpios looking for the switch? Ideally,
wouldn't it be best to load the bcm57xx module from broadcom-diag, after
it has determined which router its on?  I tried using 'request_module' from
there, but had no success.  For now, I am relying on preinit to load
the bcm57xx module with activate_gpio param, after it has failed to load
switch_robo and switch_adm.

Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>

SVN-Revision: 11471

1 files changed, 20 insertions, 0 deletions

diff --git a/package/broadcom-57xx/src/hndgige.h b/package/broadcom-57xx/src/hndgige.h
new file mode 100644
index 0000000000..cdda406cf5
--- /dev/null
+++ b/package/broadcom-57xx/src/hndgige.h
@@ -0,0 +1,20 @@
+/*
+ * HND SiliconBackplane Gigabit Ethernet core software interface.
+ *
+ * Copyright 2007, Broadcom Corporation
+ * All Rights Reserved.
+ * 
+ * THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY
+ * KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM
+ * SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS
+ * FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE.
+ *
+ * $Id: hndgige.h,v 1.5 2007/06/01 05:58:20 michael Exp $
+ */
+
+#ifndef _hndgige_h_
+#define _hndgige_h_
+
+extern void sb_gige_init(sb_t *sbh, uint32 unit, bool *rgmii);
+
+#endif /* _hndgige_h_ */