diff options
author | Andrew Pikler <andrew.pikler@gmail.com> | 2021-01-27 19:35:49 +0200 |
---|---|---|
committer | Adrian Schmutzler <freifunk@adrianschmutzler.de> | 2021-02-09 13:58:18 +0100 |
commit | cd2b661453a8a2b8260dfb9b9c0dc5297b981331 (patch) | |
tree | 5219d6fe962b8054277f1d1b6c8cb6b8ec8b9e1f /.gitattributes | |
parent | dc4745da7a3900b5dcd9158d1b83c2cda1d1b9b8 (diff) | |
download | upstream-cd2b661453a8a2b8260dfb9b9c0dc5297b981331.tar.gz upstream-cd2b661453a8a2b8260dfb9b9c0dc5297b981331.tar.bz2 upstream-cd2b661453a8a2b8260dfb9b9c0dc5297b981331.zip |
ramips: add support for Cudy WR1300
Specifications:
- SoC: MediaTek MT7621AT
- RAM: 128 MB (DDR3)
- Flash: 16 MB (SPI NOR)
- WiFi: MediaTek MT7603E, MediaTek MT7612E
- Switch: 1 WAN, 4 LAN (Gigabit)
- Ports: 1 USB 3.0
- Buttons: Reset, WPS
- LEDs: Power, System, Wan, Lan 1-4, WiFi 2.4G, WiFi 5G, WPS, USB
- Power: DC 12V 1A tip positive
UART Serial:
115200 baud
Located on unpopulated 4 pin header near J4:
J4
[o] Rx
[o] Tx
[o] GND
[ ] Vcc - Do not connect
Installation:
Download and flash the manufacturer's built OpenWRT image available at
http://www.cudytech.com/openwrt_software_download
Install the new OpenWRT image via luci (System -> Backup/Flash firmware)
Be sure to NOT keep settings. The force upgrade may need to be checked
due to differences in router naming conventions.
Recovery:
- Loads only signed manufacture firmware due to bootloader RSA verification
- serve tftp-recovery image as /recovery.bin on 192.168.1.88/24
- connect to any lan ethernet port
- power on the device while holding the reset button
- wait at least 8 seconds before releasing reset button for image to
download
- See http://www.cudytech.com/newsinfo/547425.html
MAC addresses as verified by OEM firmware:
use address source
LAN *:f0 label
WAN *:f1 label + 1
2g *:f0 label
5g *:f2 label + 2
The label MAC address is found in bdinfo 0xde00.
Signed-off-by: Andrew Pikler <andrew.pikler@gmail.com>
Diffstat (limited to '.gitattributes')
0 files changed, 0 insertions, 0 deletions