From 849369d6c66d3054688672f97d31fceb8e8230fb Mon Sep 17 00:00:00 2001 From: root Date: Fri, 25 Dec 2015 04:40:36 +0000 Subject: initial_commit --- Documentation/networking/dmfe.txt | 65 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 65 insertions(+) create mode 100644 Documentation/networking/dmfe.txt (limited to 'Documentation/networking/dmfe.txt') diff --git a/Documentation/networking/dmfe.txt b/Documentation/networking/dmfe.txt new file mode 100644 index 00000000..8006c227 --- /dev/null +++ b/Documentation/networking/dmfe.txt @@ -0,0 +1,65 @@ +Davicom DM9102(A)/DM9132/DM9801 fast ethernet driver for Linux. + +This program is free software; you can redistribute it and/or +modify it under the terms of the GNU General Public License +as published by the Free Software Foundation; either version 2 +of the License, or (at your option) any later version. + +This program is distributed in the hope that it will be useful, +but WITHOUT ANY WARRANTY; without even the implied warranty of +MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the +GNU General Public License for more details. + + +This driver provides kernel support for Davicom DM9102(A)/DM9132/DM9801 ethernet cards ( CNET +10/100 ethernet cards uses Davicom chipset too, so this driver supports CNET cards too ).If you +didn't compile this driver as a module, it will automatically load itself on boot and print a +line similar to : + + dmfe: Davicom DM9xxx net driver, version 1.36.4 (2002-01-17) + +If you compiled this driver as a module, you have to load it on boot.You can load it with command : + + insmod dmfe + +This way it will autodetect the device mode.This is the suggested way to load the module.Or you can pass +a mode= setting to module while loading, like : + + insmod dmfe mode=0 # Force 10M Half Duplex + insmod dmfe mode=1 # Force 100M Half Duplex + insmod dmfe mode=4 # Force 10M Full Duplex + insmod dmfe mode=5 # Force 100M Full Duplex + +Next you should configure your network interface with a command similar to : + + ifconfig eth0 172.22.3.18 + ^^^^^^^^^^^ + Your IP Address + +Then you may have to modify the default routing table with command : + + route add default eth0 + + +Now your ethernet card should be up and running. + + +TODO: + +Implement pci_driver::suspend() and pci_driver::resume() power management methods. +Check on 64 bit boxes. +Check and fix on big endian boxes. +Test and make sure PCI latency is now correct for all cases. + + +Authors: + +Sten Wang : Original Author +Tobias Ringstrom : Current Maintainer + +Contributors: + +Marcelo Tosatti +Alan Cox +Jeff Garzik +Vojtech Pavlik -- cgit v1.2.3