/** \file * * This file contains special DoxyGen information for the generation of the main page and other special * documentation pages. It is not a project source file. */ /** \mainpage Benito Arduino Programmer Project * * \section SSec_Compat Demo Compatibility: * * The following table indicates what microcontrollers are compatible with this demo. * * - AT90USB1287 * - AT90USB1286 * - AT90USB647 * - AT90USB646 * - ATMEGA32U6 * - ATMEGA32U4 * - ATMEGA16U4 * - AT90USB162 * - AT90USB82 * * \section SSec_Info USB Information: * * The following table gives a rundown of the USB utilization of this demo. * * * * * * * * * * * * * * * * * * * * * * * *
USB Mode:Device
USB Class:Communications Device Class (CDC)
USB Subclass:Abstract Control Model (ACM)
Relevant Standards:USBIF CDC Class StandardArduino Bootloader Specification
Usable Speeds:Full Speed Mode
* * \section SSec_Description Project Description: * * Firmware for a USB AVR powered programmer for Arduino boards using the official Arduino bootloader. This * project acts like a regular USB to Serial bridge, except that asserting the DTR line will cause a pulse * to appear on a given port pin, to control the target's /RESET pin. * * This is primarily designed to fit the Benito board from www.dorkbotpdx.org, but will suit all USB AVRs. * * After running this project for the first time on a new computer, you will need to supply the .INF file located * in this project's directory as the device's driver when running under Windows. This will enable Windows to use * its inbuilt CDC drivers, negating the need for custom drivers for the device. Other Operating Systems should * automatically use their own inbuilt CDC-ACM drivers. * * On 64 bit versions of Windows, the OS requires all drivers to be digitally signed before it will allow them to * be installed. As Windows' own CDC driver (which the supplied INF file references) is not signed, you will need * to reboot, press F8 before Windows begins to load and select "Disable Driver Signature Enforcement" to allow the * CDC driver to install. * * \section SSec_Options Project Options * * The following defines can be found in this demo, which can control the demo behaviour when defined, or changed in value. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
Define Name:Location:Description:
AVR_RESET_LINE_PORTMakefile CDEFSIndicates the PORT register of the pin used to generate the target /RESET line pulse.
AVR_RESET_LINE_DDRMakefile CDEFSIndicates the DDR register of the pin used to generate the target /RESET line pulse.
AVR_RESET_LINE_MASKMakefile CDEFSIndicates the mask of the pin used to generate the target /RESET line pulse.
AVR_RESET_PULSE_MSMakefile CDEFSPulse length in milliseconds for the target /RESET pulse.
TX_RX_LED_PULSE_MSMakefile CDEFSPulse length in milliseconds for the activity Tx/Rx LEDs.
PING_PONG_LED_PULSE_MSMakefile CDEFSPulse length in milliseconds for the enumeration LED ping-poning between toggles.
*/