/** \file * * This file contains special DoxyGen information for the generation of the main page and other special * documentation pages. It is not a project source file. */ /** \mainpage CDC Class USB AVR Bootloader * * \section Sec_Compat Demo Compatibility: * * The following list indicates what microcontrollers are compatible with this demo. * * - Series 7 USB AVRs (AT90USBxxx7) * - Series 6 USB AVRs (AT90USBxxx6) * - Series 4 USB AVRs (ATMEGAxxU4) * - Series 2 USB AVRs (AT90USBxx2, ATMEGAxxU2) * * \section Sec_Info USB Information: * * The following table gives a rundown of the USB utilization of this demo. * * * * * * * * * * * * * * * * * * * * * * *
USB Mode:Device
USB Class:Communications Device Class (CDC)
USB Subclass:Abstract Control Model (ACM)
Relevant Standards:USBIF CDC Class Standard
Usable Speeds:Full Speed Mode
* * \section Sec_Description Project Description: * * This bootloader enumerates to the host as a CDC Class device (virtual serial port), allowing for AVR109 * protocol compatible programming software to load firmware onto the AVR. * * Out of the box this bootloader builds for the USB1287, and will fit into 4KB of bootloader space. If * you wish to enlarge this space and/or change the AVR model, you will need to edit the BOOT_START and MCU * values in the accompanying makefile. * * This bootloader is compatible with the open source application AVRDUDE, or Atmel's AVRPROG. * * After running this bootloader for the first time on a new computer, you will need to supply the .INF * file located in this bootloader project's directory as the device's driver when running under Windows. * This will enable Windows to use its inbuilt CDC drivers, negating the need for custom drivers for the * device. Other Operating Systems should automatically use their own inbuilt CDC-ACM drivers. * * \section Sec_Options Project Options * * The following defines can be found in this demo, which can control the demo behaviour when defined, or changed in value. * * * * * * * * * * * * * * * * * * *
NO_BLOCK_SUPPORTMakefile LUFA_OPTSDefine to disable memory block read/write support in the bootloader, requiring all reads and writes to be made * using the byte-level commands. *
NO_EEPROM_BYTE_SUPPORTMakefile LUFA_OPTSDefine to disable EEPROM memory byte read/write support in the bootloader, requiring all EEPROM reads and writes * to be made using the block-level commands. *
NO_FLASH_BYTE_SUPPORTMakefile LUFA_OPTSDefine to disable FLASH memory byte read/write support in the bootloader, requiring all FLASH reads and writes * to be made using the block-level commands. *
NO_LOCK_BYTE_WRITE_SUPPORTMakefile LUFA_OPTSDefine to disable lock byte write support in the bootloader, preventing the lock bits from being set progmatically. *
*/