From f077204fae729e66f8dfa16db82263ff2ff84d59 Mon Sep 17 00:00:00 2001 From: Danny Date: Sat, 23 Mar 2019 20:20:14 -0400 Subject: Add support for RGB LEDs wired directly to each half's controller (#5392) * Add support for wiring RGB LEDs for both halves directly to their respective controllers RGB LEDs for each half don't need to be chained together across the TRRS cable with this * Add split RGB LED support for serial * Update config/rules for bakingpy layout * Un-nest ifdefs for hand detection * Read RGB config state from memory instead of EEPROM for serial updates * Reuse existing LED pointer instead of creating new one --- quantum/split_common/transport.c | 23 +++++++++++++++-------- 1 file changed, 15 insertions(+), 8 deletions(-) (limited to 'quantum/split_common/transport.c') diff --git a/quantum/split_common/transport.c b/quantum/split_common/transport.c index 631d913f7..8d408f6fd 100644 --- a/quantum/split_common/transport.c +++ b/quantum/split_common/transport.c @@ -92,12 +92,13 @@ typedef struct _Serial_m2s_buffer_t { # ifdef BACKLIGHT_ENABLE uint8_t backlight_level; # endif -# if defined(RGBLIGHT_ENABLE) && defined(RGBLIGHT_SPLIT) +# if defined(RGBLIGHT_ENABLE) && defined(RGBLED_SPLIT) rgblight_config_t rgblight_config; // not yet use // // When MCUs on both sides drive their respective RGB LED chains, // it is necessary to synchronize, so it is necessary to communicate RGB - // information. In that case, define the RGBLIGHT_SPLIT macro. + // information. In that case, define RGBLED_SPLIT with info on the number + // of LEDs on each half. // // Otherwise, if the master side MCU drives both sides RGB LED chains, // there is no need to communicate. @@ -132,15 +133,20 @@ bool transport_master(matrix_row_t matrix[]) { matrix[i] = serial_s2m_buffer.smatrix[i]; } -# if defined(RGBLIGHT_ENABLE) && defined(RGBLIGHT_SPLIT) - // Code to send RGB over serial goes here (not implemented yet) -# endif - # ifdef BACKLIGHT_ENABLE // Write backlight level for slave to read serial_m2s_buffer.backlight_level = backlight_config.enable ? backlight_config.level : 0; # endif +# if defined(RGBLIGHT_ENABLE) && defined(RGBLED_SPLIT) + static rgblight_config_t prev_rgb = {~0}; + uint32_t rgb = rgblight_read_dword(); + if (rgb != prev_rgb.raw) { + serial_m2s_buffer.rgblight_config.raw = rgb; + prev_rgb.raw = rgb; + } +# endif + return true; } @@ -152,8 +158,9 @@ void transport_slave(matrix_row_t matrix[]) { # ifdef BACKLIGHT_ENABLE backlight_set(serial_m2s_buffer.backlight_level); # endif -# if defined(RGBLIGHT_ENABLE) && defined(RGBLIGHT_SPLIT) -// Add serial implementation for RGB here +# if defined(RGBLIGHT_ENABLE) && defined(RGBLED_SPLIT) + // Update RGB config with the new data + rgblight_update_dword(serial_m2s_buffer.rgblight_config.raw); # endif } -- cgit v1.2.3