/* ChibiOS - Copyright (C) 2006..2018 Giovanni Di Sirio Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at http://www.apache.org/licenses/LICENSE-2.0 Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License. */ /** * @file STM32F1xx/hal_adc_lld.c * @brief STM32F1xx ADC subsystem low level driver source. * * @addtogroup ADC * @{ */ #include "hal.h" #if HAL_USE_ADC || defined(__DOXYGEN__) /*===========================================================================*/ /* Driver local definitions. */ /*===========================================================================*/ /*===========================================================================*/ /* Driver exported variables. */ /*===========================================================================*/ /** @brief ADC1 driver identifier.*/ #if STM32_ADC_USE_ADC1 || defined(__DOXYGEN__) ADCDriver ADCD1; #endif /*===========================================================================*/ /* Driver local variables and types. */ /*===========================================================================*/ /*===========================================================================*/ /* Driver local functions. */ /*===========================================================================*/ /** * @brief Shared ADC DMA ISR service routine. * * @param[in] adcp pointer to the @p ADCDriver object * @param[in] flags pre-shifted content of the ISR register */ static void adc_lld_serve_rx_interrupt(ADCDriver *adcp, uint32_t flags) { /* DMA errors handling.*/ if ((flags & STM32_DMA_ISR_TEIF) != 0) { /* DMA, this could help only if the DMA tries to access an unmapped address space or violates alignment rules.*/ _adc_isr_error_code(adcp, ADC_ERR_DMAFAILURE); } else { if ((flags & STM32_DMA_ISR_TCIF) != 0) { /* Transfer complete processing.*/ _adc_isr_full_code(adcp); } else if ((flags & STM32_DMA_ISR_HTIF) != 0) { /* Half transfer processing.*/ _adc_isr_half_code(adcp); } } } /*===========================================================================*/ /* Driver interrupt handlers. */ /*===========================================================================*/ /*===========================================================================*/ /* Driver exported functions. */ /*===========================================================================*/ /** * @brief Low level ADC driver initialization. * * @notapi */ void adc_lld_init(void) { #if STM32_ADC_USE_ADC1 /* Driver initialization.*/ adcObjectInit(&ADCD1); ADCD1.adc = ADC1; ADCD1.dmastp = NULL; ADCD1.dmamode = STM32_DMA_CR_PL(STM32_ADC_ADC1_DMA_PRIORITY) | STM32_DMA_CR_MSIZE_HWORD | STM32_DMA_CR_PSIZE_HWORD | STM32_DMA_CR_MINC | STM32_DMA_CR_TCIE | STM32_DMA_CR_TEIE; /* Temporary activation.*/ rccEnableADC1(true); ADC1->CR1 = 0; ADC1->CR2 = ADC_CR2_ADON; /* Reset calibration just to be safe.*/ ADC1->CR2 = ADC_CR2_ADON | ADC_CR2_RSTCAL; while ((ADC1->CR2 & ADC_CR2_RSTCAL) != 0) ; /* Calibration.*/ ADC1->CR2 = ADC_CR2_ADON | ADC_CR2_CAL; while ((ADC1->CR2 & ADC_CR2_CAL) != 0) ; /* Return the ADC in low power mode.*/ ADC1->CR2 = 0; rccDisableADC1(); #endif } /** * @brief Configures and activates the ADC peripheral. * * @param[in] adcp pointer to the @p ADCDriver object * * @notapi */ void adc_lld_start(ADCDriver *adcp) { /* If in stopped state then enables the ADC and DMA clocks.*/ if (adcp->state == ADC_STOP) { #if STM32_ADC_USE_ADC1 if (&ADCD1 == adcp) { adcp->dmastp = dmaStreamAllocI(STM32_DMA_STREAM_ID(1, 1), STM32_ADC_ADC1_IRQ_PRIORITY, (stm32_dmaisr_t)adc_lld_serve_rx_interrupt, (void *)adcp); osalDbgAssert(adcp->dmastp != NULL, "unable to allocate stream"); dmaStreamSetPeripheral(adcp->dmastp, &ADC1->DR); rccEnableADC1(true); } #endif /* ADC setup, the calibration procedure has already been performed during initialization.*/ adcp->adc->CR1 = 0; adcp->adc->CR2 = 0; } } /** * @brief Deactivates the ADC peripheral. * * @param[in] adcp pointer to the @p ADCDriver object * * @notapi */ void adc_lld_stop(ADCDriver *adcp) { /* If in ready state then disables the ADC clock.*/ if (adcp->state == ADC_READY) { #if STM32_ADC_USE_ADC1 if (&ADCD1 == adcp) { ADC1->CR1 = 0; ADC1->CR2 = 0; dmaStreamFreeI(adcp->dmastp); adcp->dmastp = NULL; rccDisableADC1(); } #endif } } /** * @brief Starts an ADC conversion. * * @param[in] adcp pointer to the @p ADCDriver object * * @notapi */ void adc_lld_start_conversion(ADCDriver *adcp) { uint32_t mode, cr2; const ADCConversionGroup *grpp = adcp->grpp; /* DMA setup.*/ mode = adcp->dmamode; if (grpp->circular) { mode |= STM32_DMA_CR_CIRC; if (adcp->depth > 1) { /* If circular buffer depth > 1, then the half transfer interrupt is enabled in order to allow streaming processing.*/ mode |= STM32_DMA_CR_HTIE; } } dmaStreamSetMemory0(adcp->dmastp, adcp->samples); dmaStreamSetTransactionSize(adcp->dmastp, (uint32_t)grpp->num_channels * (uint32_t)adcp->depth); dmaStreamSetMode(adcp->dmastp, mode); dmaStreamEnable(adcp->dmastp); /* ADC setup.*/ adcp->adc->CR1 = grpp->cr1 | ADC_CR1_SCAN; cr2 = grpp->cr2 | ADC_CR2_DMA | ADC_CR2_ADON; if ((cr2 & (ADC_CR2_EXTTRIG | ADC_CR2_JEXTTRIG)) == 0) cr2 |= ADC_CR2_CONT; adcp->adc->CR2 = grpp->cr2 | cr2; adcp->adc->SMPR1 = grpp->smpr1; adcp->adc->SMPR2 = grpp->smpr2; adcp->adc->SQR1 = grpp->sqr1; adcp->adc->SQR2 = grpp->sqr2; adcp->adc->SQR3 = grpp->sqr3; /* ADC start by writing ADC_CR2_ADON a second time.*/ adcp->adc->CR2 = cr2; } /** * @brief Stops an ongoing conversion. * * @param[in] adcp pointer to the @p ADCDriver object * * @notapi */ void adc_lld_stop_conversion(ADCDriver *adcp) { dmaStreamDisable(adcp->dmastp); adcp->adc->CR2 = 0; } #endif /* HAL_USE_ADC */ /** @} */