/*
 * Licensed under ST Liberty SW License Agreement V2, (the "License");
 * You may not use this file except in compliance with the License.
 * You may obtain a copy of the License at:
 *
 *        http://www.st.com/software_license_agreement_liberty_v2
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

/**
 * @defgroup SPC563 SPC563Mx Drivers
 * @details This section describes all the supported drivers on the
 *          SPC563Mx/MPC563xM platform and the implementation details
 *          of the single drivers.
 *
 * @ingroup platforms
 */

/**
 * @defgroup SPC563_HAL SPC563Mx Initialization Support
 * @details The SPC563Mx/MPC563xM HAL support is responsible for system
 *          initialization.
 *
 * @section spc563_hal_1 Supported HW resources
 * - FMPLL.
 * - INTC.
 * - XBAR.
 * - CFLASH0.
 * .
 * @section spc563_hal_2 SPC563Mx HAL driver implementation features
 * - FMPLL startup and stabilization.
 * - Clock tree initialization.
 * - Clock source selection.
 * - Flash wait states initialization based on the selected clock options.
 * - SYSTICK initialization based on current clock and kernel required rate.
 * - DMA support initialization.
 * .
 * @ingroup SPC563
 */

/**
 * @defgroup SPC563_SERIAL SPC563Mx Serial Support
 * @details The SPC563Mx/MPC563xM Serial driver uses the ESCI peripherals
 *          in a buffered, interrupt driven, implementation.
 *
 * @section spc563_serial_1 Supported HW resources
 * The serial driver can support any of the following hardware resources:
 * - ESCIA.
 * - ESCIB.
 * .
 * @section spc563_serial_2 SPC563Mx Serial driver implementation features
 * - Clock stop for reduced power usage when the driver is in stop state.
 * - Each ESCI can be independently enabled and programmed. Unused
 *   peripherals are left in low power mode.
 * - Fully interrupt driven.
 * - Programmable priority levels for each ESCI.
 * .
 * @ingroup SPC563
 */